Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: DSC HU/CM Removal/Installation

WARNING:

CAUTION:

NOTE:

1. Remove the plug hole plate..

2. Remove the bracket..


3. Remove in the order indicated in the table.

4. Install in the reverse order of removal.

5. After installation, add brake fluid, bleed the air, and inspect for fluid leakage..

6. Perform the following procedure to implement the DSC HU/CM automatic configuration.

a. Switch the ignition ON (engine off) and wait for 10 s or more

.

b. Switch the ignition to off and wait for 3 s or more

.

c. Switch the ignition ON (engine off) and wait for 3 s or more

.

d. The automatic configuration procedure is completed.

7. Perform the DSC related parts sensor initialization procedure..

8. Perform the tire pressure monitoring system initialization procedure..

9. Clear the DTCs from the memory..



1

DSC HU/CM connector

(See DSC HU/CM Connector Removal Note.)

(See DSC HU/CM Connector Installation Note.)

2

Brake pipe

(See Brake Pipe Removal Note.)

(See Brake Pipe Installation Note.)

3

Nut

4

Bolt

5

DSC HU/CM component

6

Bolt

7

DSC HU/CM

8

Bracket


DSC HU/CM Connector Removal Note

1. Pull the lock lever down in the direction of the arrow while pressing the tab of the connector cover.


2. Pull the connector toward the vehicle rear and remove it.

Brake Pipe Removal Note

1. Place an alignment mark on the brake pipe and DSC HU/CM.


2. Apply protective tape to the connector to prevent brake fluid from entering.

3. Disconnect the brake pipes.

Brake Pipe Installation Note

1. Align the marks made before removal and install the brake pipe to the DSC HU/CM and brake pipe joint referring to the figure.


2. Tighten the brake pipe to the specified torque using the commercially available flare nut wrench.

DSC HU/CM Connector Installation Note

1. Connect the connector and pull the lock lever up in the direction of the arrow.


2. After connecting the connector, verify that the connector cover is completely pushed in.

DSC HU/CM Inspection
1. Disconnect the DSC HU/CM connector.. 2. Connect the negative battery cable.. 3. Attach the tester lead to the DSC HU/CM wiring harness-side connector and inspect voltage, continuity, or resis ...

DSC Related Parts Sensor Initialization Procedure
WARNING: If the initialization procedure is not completed, the DSC will not operate properly and it might cause an unexpected accident. Therefore, after replacing or removing the DSC HU/ ...

Other materials:

Presilencer
Purpose, Function Reduces the exhaust noise. Construction The presilencer is installed to the rear of the TWC. 2WD AWD The presilencer consists of the filters, stuffing and wool-stainless. 2WD AWD ...

Liftgate Latch And Lock Actuator Inspection
The following actuator and switch are integrated with the liftgate latch and lock actuator. From the actuator/switch name and operation in the following table, select the actuator or switch to be inspected, and perform the inspection following the inspection procedure desc ...

Rear Seat Back Frame Removal/Installation
CAUTION: When performing the procedure with a rear seat removed from the vehicle, perform the procedure on a clean cloth so as not to damage or soil the seat. 6:4 Split Type 1. Remove the trunk board.. 2. Remove the rear seat back.. 3. Remove the headrest. 4. Open fasteners A ...

© 2016-2024 Copyright www.mcx5.org