Mazda CX-5 Service & Repair Manual: Driver Info & Control

Theft Deterrent Horn Removal/Installation

1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Trunk end trim. b. Rear scuff plate (RH). c. Trunk side trim (RH). 3. Disconnect the connector. 4. Remove t ...

General

...

Other materials:

Not P Position Switch Inspection
NOTE: The not P position switch is built into the selector lever component. 1. Disconnect the negative battery cable.. 2. Remove the front console.. 3. Disconnect the selector lever component connector. 4. Verify that the continuity between selector lever component terminals ...

Air Fuel Ratio (A/F) Sensor Inspection
A/F Sensor Inspection 1. Connect the M-MDS to the DLC?2. 2. Switch the ignition ON (engine on). 3. Warm up the engine to normal operating temperature. 4. Access the following PIDs using the M-MDS.. VSS (Vehicle speed) RPM (Engine speed) O2S11 (A/F sensor output current ...

Blind Spot Monitoring (Bsm) Control Module Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the rear combination light.. 3. Remove the rear bumper.. 4. Disconnect the connector. 5. Remove the nuts. 6. Remove the BSM control module. 7. Install in the reverse order of removal. 8. Perform the BSM radar test.. CAUTION: ...