Mazda CX-5 Service & Repair Manual: Driveline/Axle SST
Front and Rear Axle
|
49 T028 3A0 Ball joint puller set |
|
49 T028 301 Dust boot installer |
|
49 U034 204 Dust boot installer |
|
|
49 W032 310 Support block |
|
— |
— |
||
Drive Shaft
|
49 B025 017 Sliding hammer |
|
49 B025 010 Attachment A |
|
49 H027 002 Bearing remover |
|
|
49 W032 310 Support block |
|
49 T025 001 Boot clamp crimpers |
|
49 UB71 525 Bearing installer |
|
Differential
|
49 D028 203 Support block |
|
49 W034 201 Dust boot installer |
|
49 0107 680A Engine stand |
|
|
49 L027 0A2 Diff hanger set |
|
49 T032 317 Weight |
|
49 T032 316 Shaft |
|
|
49 L027 004 Gear case remover |
|
49 L027 006 Serrate socket |
|
49 L027 007 Hex socket |
|
|
49 H027 002 Bearing remover |
|
49 0839 425C Bearing puller set |
|
49 F401 331 Bearing installer body |
|
|
49 G030 338 Attachment E |
|
49 M005 797 Oil seal installer |
|
49 L025 002 Bearing installer |
|
|
49 F027 007 Attachment o 72 |
|
49 V001 525 Bearing installer |
|
49 B032 335A Oil seal installer |
|
Transfer
|
49 T034 201A Dust boot installer |
|
49 V001 795 Oil seal installer |
|
49 F034 201 Dust boot installer |
|
|
49 F019 001 Oil seal installer |
|
— |
— |
||
Driveline/Axle Features
Improved driveability
Bell-shaped constant velocity joint adopted for wheel-side joint
of front and rear drive shaft
Tripod-shaped constant velocit ...
General Procedures (Front And Rear Axles)
Wheel and Tire Installation
1. When installing the wheels and tires, tighten the wheel nuts in a criss-cross
pattern to the following tightening torque.
Tightening torque
108—147 N ...
Other materials:
Front Heat Duct Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Dashboard under cover.
b. Side wall.
c. Glove compartment.
3. Detach the tab and remove the front heat duct.
LH
RH
4. Install in the reverse order of removal. ...
Control Valve Body [Fw6 A EL, Fw6 Ax EL]
Purpose/Function
The control valve body controls the hydraulic pressure generated by the oil
pump by each solenoid valve. In addition, the oil passages which introduce hydraulic
pressure to the pistons for each clutch and brake is formed by the switching
of each built-in shift valve. ...
Liftgate Hinge Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Rear scuff plate.
b. Trunk end trim.
c. Trunk side trim.
d. C-pillar trim.
e. D-pillar trim.
f. Liftgate.
3. Remove fasteners.
4. While partially peeling back the rear part of the headliner, remove nut ...
