Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Driveline/Axle Features


Improved driveability

  • Bell-shaped constant velocity joint adopted for wheel-side joint of front and rear drive shaft

  • Tripod-shaped constant velocity joint adopted for differential-side joint of front drive shaft (ATX) and rear drive shaft

  • Double offset-shaped constant velocity joint adopted for differential-side joint of front drive shaft (MTX)

Improved rigidity, reduced noise and vibration

  • Characteristics of front drive shaft optimized

  • Constant velocity joint type rear drive shaft adopted (AWD)

  • 2-part, 1-joint type propeller shaft with middle shaft bearing has been adopted

Improved off-road mobility, handling stability and marketability

  • Electronic AWD control system adopted

Size and weight reduction

  • Rear differential with an integrated coupling component adopted

  • Aluminum differential carrier adopted

Improved serviceability

  • Self diagnostic function adopted for electronic AWD control system

  • A maintenance-free transfer has been adopted


Driveline/Axle Abbreviations
AAS Active Adaptive Shift ABS Antilock Brake System ABDC After Bottom Dead Center ACC Access ...

Driveline/Axle SST
Front and Rear Axle 49 T028 3A0 Ball joint puller set 49 T028 301 Dust boot installer 49 U034 204 Dust boot installer ...

Other materials:

Camshaft Position (CMP) Sensor
Purpose/Function Detects the camshaft speed as basic information for mainly determining the fuel injection timing and ignition timing. Detects the camshaft speed and inputs it to the PCM as a CMP signal. Construction Intake CMP sensor Installed on the cylinder head. ...

Cruise Control Switch Inspection
1. Disconnect the negative battery cable and wait for 1 min or more.. 2. Remove the driver?side air bag module.. 3. Disconnect the clock spring connector (part wiring harness-side). 4. Measure the resistance between clock spring terminals E and A (part wiring harness-side) using a tester. ...

Oil Jet Valve
Purpose, Function The oil jet valve injects engine oil on the back of the piston to cool the piston. Construction The oil jet valve is installed into the cylinder block. The oil jet valve is built into the check ball and spring. Operation 1. When ...

© 2016-2022 Copyright www.mcx5.org