Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Drive Plate Removal/Installation [Fw6 A EL, Fw6 Ax EL]

Mazda CX-5 Service & Repair Manual / Drivetrain / Transmission/Transaxle / Automatic / Drive Plate Removal/Installation [Fw6 A EL, Fw6 Ax EL]

1. Remove the transaxle..

2. Remove in the order indicated in the table.



1

Drive plate installation bolts

(See Drive Plate Installation Bolts Removal Note.)

(See Drive Plate Installation Bolts Installation Note.)

2

Backing plate

3

Drive plate


3. Install in the reverse order of removal.

Drive Plate Installation Bolts Removal Note

1. Set the SST

against the drive plate.


2. Loosen the drive plate installation bolts uniformly in two or three steps in the order shown in the figure, then remove the bolts and the drive plate.

Drive Plate Installation Bolts Installation Note

1. Set the SST

against the drive plate.


2. Tighten the new drive plate installation bolts uniformly in two or three steps in the order shown in the figure.

Down Switch [Fw6 A EL, Fw6 Ax EL]
Purpose/Function The down switch detects the shift down operation of the selector lever. The down switch signal is sent to the TCM via CAN and is used for manual shift control and en ...

Front Seat Side Cover Removal/Installation
WARNING: Handling a side air bag improperly can accidentally operate (deploy) the air bag, which may seriously injure you. Read the service warnings in the Workshop Manual before handlin ...

Other materials:

Rear Window Defroster/Outer Mirror Heater
Outline Fogging is cleared from the rear window and outer mirror glass by heating of the filament. Structural view System wiring diagram Vehicles with full-auto air conditioner system Vehicles with manual air conditioner system Construction Rear window defroster ...

Crankshaft Position (CKP) Sensor
Purpose/Function Detects the crankshaft speed as basic information for mainly determining the fuel injection timing and ignition timing. Detects the crankshaft speed and inputs it to the PCM as a CKP signal. Construction Installed on the side of the cylinder block (ri ...

Wiper And Washer Switch Removal/Installation
1. Switch the ignition ON (engine off or on). 2. Open the driver's door. 3. Switch the ignition OFF. 4. Disconnect the negative battery cable.. 5. Remove the column cover.. 6. Rotate the steering wheel in the direction of the arrow shown in the figure to the angle where the service h ...

© 2016-2022 Copyright www.mcx5.org