Generator Drive Belt
NOTE:
The generator drive belt deflection/tension inspection is not necessary with the adoption of the drive belt auto tensioner.
1. Verify that the indicator part of the cast hexagon on the drive belt auto tensioner is within the normal range.
If it exceeds the limit, replace the drive belt..
Water Pump Drive Belt
NOTE:
The water pump drive belt deflection/tension inspection is not necessary with the adoption of the stretch-type water pump drive belt.
1. Visually inspect or feel that there is no wear, damage, or cracking on the inside and sides of the entire the belt.
Even if there is a little wear, damage, or cracking, replace the water pump drive belt..
2. Start the engine to verify that abnormal noise does not occur.
If abnormal noise occurs, replace the water pump drive belt..
Front Combination Light Disassembly/Assembly
1. Disassemble in the order shown in the figure.
Halogen type
1
Short cord
(See Short Cord Removal Note.)
2
Parking/Front turn light bulb
(See PARKING/FRONT TURN LIGHT BULB REMOVAL/INSTALLATION.)
3
Headlight ...
Filament Repair
1. Clean the filament using isopropyl alcohol.
2. Attach tape to both sides of the filament.
3. Using a small brush or marking pen, apply silver paint.
4. After 2—3 min, carefully remove the tape without damaging the applied
area.
CAUTION:
Do not operate the rear window defro ...
Cruise Main Indicator Light (Amber)
Purpose/Function
Illuminates while the cruise control system is in standby mode to inform
the driver that the cruise control system is on standby.
Construction
Built into the instrument cluster.
Operation
Illuminates while the cruise control system is on sta ...