Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Down Switch Inspection [Fw6 A EL, Fw6 Ax EL]

Mazda CX-5 Service & Repair Manual / Drivetrain / Transmission/Transaxle / Automatic / Down Switch Inspection [Fw6 A EL, Fw6 Ax EL]

Continuity Inspection

NOTE:

1. Disconnect the negative battery cable..

2. Remove the front console..

3. Disconnect the selector lever component connector.


4. Verify that the continuity between selector lever component terminals D and J.


Down switch specification

Test condition

Continuity

Selector lever is in the M position (?) side position.

Continuity

Selector lever is not in the M position (?) side position.

No continuity


Coupler Component Removal/Installation [Fw6 A EL, Fw6 Ax EL]
WARNING: A hot transaxle and ATF can cause severe burns. Turn off the engine and wait until they are cool. Always wear protective eye wear when using the air compressor. If the ...

Down Switch [Fw6 A EL, Fw6 Ax EL]
Purpose/Function The down switch detects the shift down operation of the selector lever. The down switch signal is sent to the TCM via CAN and is used for manual shift control and en ...

Other materials:

Supplemental Restraint System (SRS) Precautions
The front and side supplemental restraint systems (SRS) include up to 6 air bags. Please verify which kinds of air bags are equipped on your vehicle by locating the “SRS AIRBAG” location indicators. These indicators are visible in the area where the air bags are installed. The air bags ar ...

SRS Air Bag Deployment Criteria
This chart indicates the applicable SRS equipment that will deploy depending on the type of collision. (The illustrations are the representative cases of collisions.) X: The SRS air bag equipment is designed to deploy in a collision. *1 (With Driver and Front Passenger Occupant Classification ...

Up Switch Inspection [Fw6 A EL, Fw6 Ax EL]
Continuity Inspection NOTE: The up switch is built into the selector lever component. 1. Disconnect the negative battery cable.. 2. Remove the front console.. 3. Disconnect the selector lever component connector. 4. Verify that the continuity between selector lever component ...

© 2016-2026 Copyright www.mcx5.org