Mazda CX-5 Service & Repair Manual: Down Switch [Fw6 A EL, Fw6 Ax EL]
Purpose/Function
-
The down switch detects the shift down operation of the selector lever.
-
The down switch signal is sent to the TCM via CAN and is used for manual shift control and engine-transaxle integration control.
Construction
-
The down switch is installed to the selector lever.
-
The down switch is an on/off type switch.
Operation
-
When the selector lever is in the shift down position (-), the down switch contact point closes.
-
Based on the opening and closing of the down switch contact point, the TCM detects that the shift down has been operated.
Down Switch Inspection [Fw6 A EL, Fw6 Ax EL]
Continuity Inspection
NOTE:
The down switch is built into the selector lever component.
1. Disconnect the negative battery cable..
2. Remove the front console..
3. Disconnect the se ...
Drive Plate Removal/Installation [Fw6 A EL, Fw6 Ax EL]
1. Remove the transaxle..
2. Remove in the order indicated in the table.
1
Drive plate installation bolts
(See Drive Plate Installation Bolts Removal Note.)
(See ...
Other materials:
Break-In Period
No special break-in is necessary, but a few precautions in the first 1,000 km
(600 miles) may add to the performance, economy, and life of your Mazda.
• Do not race the engine.
• Do not maintain one constant speed,
either slow or fast, for a long period of time.
• Do not drive constantl ...
Fuel-Filler Lid and Cap
WARNING
When removing the fuel-filler cap, loosen the cap slightly and wait for any hissing
to stop. Then remove it:
Fuel spray is dangerous. Fuel can burn skin and eyes and cause illness if ingested.
Fuel spray is released when there is pressure in the fuel tank and the fuel-filler
cap is r ...
Filament Inspection
1. Switch the ignition ON (engine off).
2. Turn the rear window defroster switch on.
CAUTION:
Directly touching the rear window defroster filament with the lead of the
tester could damage it. Wrap aluminum foil around the end of the lead and inspect
the filament by touching it ...