Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Differentials

Wheel Hub Component Removal/Installation [Awd]
CAUTION: Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the wiring harness if it is pulled by mistake. Before ...

Differential Oil Inspection
1. Place the vehicle on level ground. 2. Remove the filler plug and washer. 3. Verify that the oil is at the brim of the filler plug hole. 4. If it is low, add the specified oil. 5. Instal ...

Other materials:

Clutch [C66 M R]
Purpose, Function The clutch unit transmits or cuts the drive force between the engine and MTX according to the clutch pedal operation. Construction/Operation The construction/operation of the clutch unit is the same as the original MTX (ex: G66M-R). ...

Accelerator Pedal Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove in the order indicated in the table. 1 APP sensor connector 2 Accelerator pedal 3. Install in the reverse order of removal. ...

Knock Sensor (Ks)
Purpose/Function Detects abnormal combustion in the cylinder as basic information for mainly determining the ignition timing. Detects abnormal combustion in the combustion chamber and inputs it to the PCM as a knocking signal. Construction Installed on the cylinder ...

© 2016-2026 Copyright www.mcx5.org