Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Differential Oil Temperature Sensor Inspection

Mazda CX-5 Service & Repair Manual / Drivetrain / Driveline / Differentials / Differential Oil Temperature Sensor Inspection

WARNING:

1. Disconnect the negative battery cable.

2. Disconnect the differential oil temperature sensor connector and remove the differential oil temperature sensor.

3. Wrap the differential oil temperature sensor with plastic wrap and immerse it into a beaker filled with water. Gradually raise the water temperature, and measure resistance between differential oil temperature sensor terminals A and B.


Differential oil temperature sensor specification

Water temperature (°C {°F})

Resistance (kilohm)

0 {32}

91—100

10 {50}

56—61

20 {68}

35—39

30 {86}

23—25

40 {104}

15—16

50 {122}

10—11

60 {140}

7.1—7.9

70 {158}

5.0—5.6

80 {176}

3.6—4.0


4. Install the differential oil temperature sensor and connect the connector.

5. Connect the negative battery cable..

Differential Oil Temperature Sensor
Purpose, Function The differential oil temperature sensor detects the rear differential oil temperature based on the resistance of the thermistor, and inputs it to the AWD CM. Const ...

Differential Oil Temperature Sensor Removal/Installation
WARNING: Hot differential oil may cause severe burns. Do not perform maintenance while differential oil is hot. 1. Disconnect the negative battery cable. 2. Disconnect the different ...

Other materials:

Refrigerant Line Removal/Installation
1. Disconnect the negative battery cable.. 2. Discharge the refrigerant.. 3. Disconnect the engine ground. 4. Disconnect the refrigerant pressure sensor connector. 5. Remove in the order indicated in the table. Do not allow compressor oil to spill. CAUTION: If moisture or for ...

Front Brake (Disc) Removal/Installation
1. Remove in the order indicated in the table. 2. Install in the reverse order of removal. 3. After installation, add brake fluid, bleed the air, and inspect for fluid leakage.. 4. Depress the brake pedal a few times, rotate the wheel by hand, and verify that the brake does not drag. ...

Theft Deterrent Horn Inspection
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Trunk end trim. b. Rear scuff plate (RH). c. Trunk side trim (RH). d. Theft-deterrent horn. 3. Apply battery positive voltage to horn terminal A, and connect the horn retaining bolt to ground as shown in the f ...

© 2016-2026 Copyright www.mcx5.org