Mazda CX-5 Service & Repair Manual: Differential Oil Temperature Sensor
Purpose, Function
-
The differential oil temperature sensor detects the rear differential oil temperature based on the resistance of the thermistor, and inputs it to the AWD CM.
Construction
-
The differential oil temperature sensor is installed in the rear differential carrier.
Operation
-
The differential oil temperature sensor uses a thermistor whose resistance changes according to changes in the rear differential oil temperature.
-
The resistance grows smaller as the oil temperature rises and vice-versa, as shown.
Fail-safe
|
DTC |
Fail-safe |
|
P1888:11 P1888:15 |
Control disabled. |
Differential Oil Replacement
1. Place the vehicle on level ground.
2. Remove the filler plug.
3. Remove the drain plug and drain the differential oil into a container.
4. Install a new washer and the drain plug, and tig ...
Differential Oil Temperature Sensor Inspection
WARNING:
Hot differential oil may cause severe burns. Do not perform maintenance while
differential oil is hot.
1. Disconnect the negative battery cable.
2. Disconnect the different ...
Other materials:
Fuel Injector Removal/Installation
WARNING:
Fuel is very flammable liquid. If fuel spills or leaks from the pressurized
fuel system, it will cause serious injury or death and facility breakage. Fuel
can also irritate skin and eyes. To prevent this, always complete the “Fuel
Line Safety Procedure”, while referring ...
Power Window Main Switch
Purpose
Remote control of door glass open/close and power outer mirror adjustment
are possible with occupant seated in the cabin.
Function
Power window main switch
Manual
When the power window main switch is operated for manual open/close operation,
it sends ...
Refrigerant Pressure Sensor Inspection [Manual Air Conditioner]
1. Install the manifold gauge.
2. Verify the high-pressure side reading of the manifold gauge.
3. Measure the terminal voltage at PCM terminals 2BB, 2AX and 2AJ
4. Using the graph below, measure and verify the terminal voltage at 2AX.
5. Follow the PCM inspection when measuring the other ter ...
