Purpose/Function
The differential absorbs the difference in the rotation speed between the left and right driving wheels so that the vehicle drives smoothly when differences occur due to cornering or driving on rough roads.
Construction
The differential consists of the ring gear, differential gear case, side gears, pinion gears, and pinion shaft.
The differential gear case is engaged with the ring gear and rotates as a single unit.
The side gears are engaged with the drive shaft (LH) and drive shaft (RH) and rotates as a single unit for each.
Operation
If there is no difference in rotation speed between the left and right driving wheels, the left and right side gears rotate together with the differential gear case and pinion gears.
If there is a difference in the rotation speed between the left and right driving wheels, the difference in the rotation speed between the left and right side gears is absorbed by the pinion gears rotating around the pinion shaft.
Front Wiring Harness Protector Removal/Installation
Front Wiring Harness Protector No.1
1. Disconnect the negative battery cable..
2. Remove the air cleaner case..
3. While pressing the tabs of clip A in the direction of the arrows (1) shown
in the figure, pull clip A in the direction of the arrow (2) shown in the figure
to detach the tab of ...
Underbody Dimensions [Dimensions]
NOTE:
The following figure is a bottom view.
Point symbol
Designation
Hole diameter or bolt or nut size mm {in}
A
Front crossmember installation hole
?24 {0.94}
B
Fro ...
Heater Hose Removal/Installation
With Water Temperature Sensor
1. Remove the battery..
2. Drain the engine coolant..
3. Remove the insulator.
4. Remove the clips and remove the heater hose.
5. Remove the heater hose.
6. Install in the reverse order of the removal.
7. Inspect for engine coolant leaka ...