Mazda CX-5 Service & Repair Manual: Data Network
- Active Command Modes Inspection [Front Body Control Module (Fbcm)]
- Active Command Modes Inspection [Rear Body Control Module (Rbcm)]
- Controller Area Network (Can)
- Controller Area Network (Can)
- Controller Area Network (Can) Outline
- Controller Area Network (Can) System
- Front Body Control Module (Fbcm)
- Front Body Control Module (Fbcm) Configuration (Using As Built Data)
- Front Body Control Module (Fbcm) Configuration (Using Read/Write Function)
- Front Body Control Module (Fbcm) Inspection
- Front Body Control Module (Fbcm) Removal/Installation
- Main Relay Control [Skyactiv G 2.0]
- Multiplex Communication System
- On Board Diagnostic System PID/Data Monitor Inspection [Fw6 A EL, Fw6 Ax EL]
- On Board Diagnostic System Simulation Inspection [Fw6 A EL, Fw6 Ax EL]
- PID/Data Monitor Inspection [Front Body Control Module (Fbcm)]
- PID/Data Monitor Inspection [Rear Body Control Module (Rbcm)]
- Rear Body Control Module (Rbcm)
- Rear Body Control Module (Rbcm) Configuration (Using As Built Data)
- Rear Body Control Module (Rbcm) Configuration (Using Read/Write Function)
- Rear Body Control Module (Rbcm) Inspection
- Rear Body Control Module (Rbcm) Removal/Installation
Spark Plug [Skyactiv G 2.0]
Purpose, Function
The spark plug generates spark, ignition of the air-fuel mixture occurs,
and combustion of the air-fuel mixture is triggered.
Construction
The spark plug is in ...
Active Command Modes Inspection [Front Body Control Module (Fbcm)]
1. Connect the M-MDS to the DLC-2.
2. After the vehicle is identified, select the following items from the initialization
screen of the M-MDS.
a. Select “DataLogger”.
b. Select “Modules ...
Other materials:
Barometric Pressure (Baro) Sensor Inspection
Voltage Inspection
NOTE:
Because the BARO sensor is integrated in the PCM, replacing the BARO sensor
includes replacement of the PCM.
1. Connect the M-MDS to the DLC?2.
2. Switch the ignition ON (engine off or on).
3. Verify that the BARO sensor output voltage (PID: BARO) is wi ...
Coolant Reserve Tank Removal/Installation
1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.
1
Wiring harness
2
Hose
3
Coolant reserve tank
(See Coolant Reserve Tank Removal Note.)
Coolant Reserve Ta ...
Turn Signal/Hazard Warning Indicator Lights
Purpose
Notifies the driver that a turn light, the hazard warning lights are flashing.
Function
Flashes according to the turn switch and hazard warning switch operations.
Construction
Displayed in the instrument cluster.
Operation
Turn system
1. When th ...
