Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: D Pillar Speaker Inspection

D-pillar speaker

1. Disconnect the negative battery cable..

2. Remove the following parts:

a. Trunk board.

b. Trunk end trim.

c. Rear scuff plate.

d. Trunk side trim.

e. D-pillar trim.

3. Disconnect the D-pillar speaker connector..

4. Verify that the resistance between the D-pillar speaker terminals is as indicated in the table.


Short-cord

1. Disconnect the negative battery cable..

2. Remove the following parts:

a. Trunk board.

b. Trunk end trim.

c. Rear scuff plate.

d. Trunk side trim.

e. D-pillar trim.

3. Disconnect the D-pillar speaker connector..

4. Verify that the continuity between the short-cord terminals is as indicated in the table.


Coil Antenna
Purpose Sends the ID data programmed to the electronic transmission device (transponder) in the remote transmitter to the start stop unit. Function A magnetic field occurs aroun ...

D Pillar Speaker Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Trunk board. b. Trunk end trim. c. Rear scuff plate. d. Trunk side trim. e. D-pillar trim. 3. Disconnect the ...

Other materials:

Differential Oil Temperature Sensor Removal/Installation
WARNING: Hot differential oil may cause severe burns. Do not perform maintenance while differential oil is hot. 1. Disconnect the negative battery cable. 2. Disconnect the differential oil temperature sensor connector. 3. Remove the differential oil temperature sensor. 4. ...

Moonroof
The moonroof can be opened or closed electrically only when the ignition is switched ON. WARNING Do not let passengers stand up or extend part of the body through the open moonroof while the vehicle is moving: Extending the head, arms, or other parts of the body through the moonroof is da ...

Corner Junction Installation [Panel Replacement]
Symbol Mark Installation Procedure 1. When installing new parts, measure and adjust the body as necessary to conform with standard dimensions. 2. Drill holes for the plug welding before installing the new parts. 3. After temporarily installing new parts, make sure the related parts fit p ...

© 2016-2024 Copyright www.mcx5.org