Mazda CX-5 Service & Repair Manual: Crank, Balancer

Engine Front Cover

Purpose, Function The engine front cover covers the front of the engine to prevent engine oil spillage, noise leakage, and foreign material penetration. Construction The engine ...

Crankshaft Position (CKP) Sensor Inspection

Visual Inspection CAUTION: When foreign material such as an iron chip is on the CKP sensor, it can cause abnormal output from the sensor because of flux turbulence and adversely affect ...

Other materials:

Rear Body Control Module (Rbcm) Configuration (Using Read/Write Function)
NOTE: When performing configuration, it is necessary to read the vehicle specification information from the rear body control module (RBCM) before replacing it. Connect the M-MDS to the vehicle and perform vehicle identification before removing the rear body control module (RBCM). T ...

Thermostat Inspection
1. Remove the thermostat.. 2. Visually check that the thermostat valve is closed. 3. Place the thermostat in water. WARNING: During inspection, the thermostat and water are extremely hot and can cause severe burns. Do not touch the thermostat and water. 4. Heat the water and c ...

Antenna Feeder No.2 Removal/Installation
Removal 1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Sunroof seaming welt (with sunroof system). b. A-pillar trim. c. Front map light. d. Sunvisor. e. Front scuff plate. f. Rear scuff plate. g. B-pillar lower trim. h. Adjust anchor cover. i. Upper ...