Mazda CX-5 Service & Repair Manual: Coupling Component Calibration Data Writing
1. Connect the M-MDS to the DLC-2.
2. After the vehicle is identified, select the following items from the toolbox of the M-MDS.
-
Select “Chassis”.
3. Then, select items from the screen menu in the following order.
-
Select “4WD/AWD”.
-
Select “Coupling Calibration Data Writing”.
4. Perform the configuration according to the directions on the screen.
CAUTION:
-
When the configuration is performed, CAN communication between the AWD control module and control module connected to the CAN line is cut temporarily, and communication error DTCs may be detected. After performing the configuration, verify the DTCs for the control module connected to the CAN line and clear it if any DTC is detected.
5. Verify all the DTCs for the control module connected to the CAN line.
-
If any DTC is stored, clear it.
-
If the DTC is cleared, finish the procedure because the configuration is completely normally.
-
If the DTC remains, perform troubleshooting according to the DTC.
Awd Warning Light
Purpose, Function
Warns the driver of a AWD system malfunction.
Construction
The AWD warning light is built into the instrument cluster.
Operation
If the self-di ...
Coupling Component Removal/Installation
WARNING:
When replacing the coupling component, read the special character string
before installing a new coupling component and write it to the AWD control module
after replacement. The ...
Other materials:
Rear Drive Shaft
Purpose, Function
Engine noise and vibration have been reduced due to adoption of a bell joint
on the wheel side of the constant velocity joint.
A low noise and vibration double offset joint with low slide resistance has
been adopted for the differential side of the constant v ...
Front Seat
Seat Operation
1 Seat Slide
(Manual Seat) To move a seat forward or backward, raise the lever and slide
the seat to the desired position and release the lever.
Make sure the lever returns to its original position and the seat is locked in
place by attempting to push it forward and backward. ...
Speaker [Without Bose®]
Purpose
Converts the audio signal from the audio unit to sound.
Function
Full-range speakers, which can output wide-range sound from low to high frequency,
have been adopted.
Specification
Item
Front door speaker
Rear speaker ...
