Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Coupler Component Removal/Installation [Fw6 A EL, Fw6 Ax EL]

Mazda CX-5 Service & Repair Manual / Drivetrain / Transmission/Transaxle / Automatic / Coupler Component Removal/Installation [Fw6 A EL, Fw6 Ax EL]

WARNING:

CAUTION:

1. Select the selector lever to P position.

2. Disconnect the negative battery cable..

3. Remove the front under cover No.2..

4. Clean the transaxle exterior throughout with a steam cleaner or cleaning solvents.

5. Remove the air cleaner component..

6. Remove the control valve body..

7. Remove the oil seal (control valve body)..

8. Disconnect the coupler component connectors.

CAUTION:


a. Disconnect connector A and connector C by pressing the connector tab with your fingers.

b. Insert a precision flathead screwdriver and move it in the direction of the arrow to disconnect connector B as shown in the figure.


9. Remove the coupler component.


CAUTION:

10. Temporarily install the coupler component so that the oil strainer installation bolt hole does not deviate.


11. After verifying that the oil strainer installation bolt hole is not deviated, install the coupler component.

CAUTION:


12. Connect the coupler component connectors.


13. Install the control valve body..

14. Install the front under cover No.2..

15. Install the oil seal (control valve body)..

16. Install the hose clamp..

17. Connect the control valve body connector..

CAUTION:

18. Add the ATF..

19. Install the air cleaner component..

20. Connect the negative battery cable..

21. Perform the “Mechanical System Test”..

Control Valve Body [Fw6 A EL, Fw6 Ax EL]
Purpose/Function The control valve body controls the hydraulic pressure generated by the oil pump by each solenoid valve. In addition, the oil passages which introduce hydraulic pressure ...

Down Switch Inspection [Fw6 A EL, Fw6 Ax EL]
Continuity Inspection NOTE: The down switch is built into the selector lever component. 1. Disconnect the negative battery cable.. 2. Remove the front console.. 3. Disconnect the se ...

Other materials:

Cowl Upper Plate Removal [Panel Replacement]
Symbol Mark Removal Procedure 1. Drill the 9 locations indicated by (A) shown in the figure. 2. Drill the 2 locations by (B) from the front wheel housing side shown in the figure. 3. Drill the 2 locations indicated by (C) from the inside shown in the figure. 4. Remove the cowl upp ...

Canister Vent (Cv) Solenoid Valve Removal/Installation
U.S.A. And CANADA 1. Disconnect the negative battery cable.. 2. Remove the floor under cover (LH).. 3. Disconnect the evaporative hose No.2.. 4. Remove in the order indicated in the table. 1 CV solenoid valve connector 2 CV solenoid va ...

Valve, Valve Spring, Valve Seal, Valve Guide
Purpose, Function Valve The intake valve is pressed down by the cam, the intake air passage is opened, and air is introduced into the cylinder. The exhaust valve is pressed down by the cam, the exhaust air passage is opened, and combustion gas is exhausted from the cylinder. ...

© 2016-2022 Copyright www.mcx5.org