Symbol Mark
Installation Procedure
1. When installing new parts, measure and adjust the body as necessary to conform with standard dimensions.
2. Drill holes for the plug welding before installing the new parts.
3. After temporarily installing new parts, make sure the related parts fit properly.
4. Plug weld the 3 locations indicated by (A) shown in the figure.
5. Spot weld the 11 locations by (B) shown in the figure, then install the corner plate.
Oil Strainer
Purpose, Function
The oil strainer suctions the engine oil in the oil pan using the oil pump
vacuum. The engine oil is filtered by the internal filter at that time.
Construction
The oil strainer is installed on the suction port of the oil pump.
The oil strain ...
Instrumentation/Driver Info. Personalization
A personalization function has been adopted which enables the instrument
cluster settings to be changed.
The Mazda Modular Diagnostic System (M-MDS) is required to perform the setting.
Refer to the Workshop Manual for the detailed setting procedure.
Instrument cluster
...
Automatic Transaxle Removal/Installation [Fw6 A EL]
CAUTION:
Performing the following procedures without first removing the front ABS
wheel-speed sensor may possibly cause an open circuit in the harness if it is
pulled by mistake. Before performing the following procedures, disconnect the
front ABS wheel-speed sensor (axle side) and ...