Mazda CX-5 Service & Repair Manual: Cooling System

Mazda CX-5 Service & Repair Manual / Engine / Cooling / Cooling System

Outline

Passing water resistance is reduced by improvement of the engine coolant passage shape.
Pump efficiency is improved by changing the water pump impeller to the closed impeller.

Structural View

Flow Chart

Structure

Consists of the following parts:

Radiator	(See RADIATOR [SKYACTIV-G 2.0].)
Cooling system cap	(See COOLING SYSTEM CAP [SKYACTIV-G 2.0].)
Thermostat	(See THERMOSTAT [SKYACTIV-G 2.0].)
Water pump	(See WATER PUMP [SKYACTIV-G 2.0].)
Cooling fan component	(See COOLING FAN COMPONENT [SKYACTIV-G 2.0].)
Cooling fan relay	(See COOLING FAN RELAY [SKYACTIV-G 2.0].)

Cooling System Service Warnings

WARNING: Never remove the cooling system cap or loosen the radiator drain plug while the engine is running, or when the engine and radiator are hot. Scalding engine coolant and steam may ...

Electrical Fan Control

Outline Through cooling of the radiator and condenser by operation of the cooling fan according to vehicle conditions, engine reliability and cooling performance have been improved. ...

Other materials:

Bsm Indicator Light Does Not Flash While Under Bsm Indicator Light Flashing Conditions (With Combination Switch Operation (Turn Signal Switch)) [Blind Spot Monitoring (Bsm)]
Description BSM indicator light does not flash while under BSM indicator light-flashing conditions (with combination switch operation (turn signal switch)) The BSM indicator light does not flash or illuminate continuously, but the cond ...

Propeller Shaft Removal/Installation
CAUTION: If the constant velocity joint is bent during propeller shaft removal/installation or transportation after servicing, the constant velocity joint boot may contact the metallic cover and the boot may be damaged. Insert a rag between the boot and the metallic cover before ser ...

Evaporator Temperature Sensor Inspection [Manual Air Conditioner]
NOTE: Inspect the evaporator temperature sensor when it is installed to the A/C unit. 1. Set the fan speed at MAX HI. 2. Set the temperature control at MAX COLD. 3. Set the RECIRCULATE mode. 4. Turn the A/C switch off. 5. Close all doors and windows. 6. Wait for 5 min. 7 ...