Mazda CX-5 Service & Repair Manual: Cooling
- Coolant Reserve Tank Removal/Installation
- Cooling Fan Component
- Cooling Fan Motor Inspection
- Cooling Fan Motor Removal/Installation
- Cooling System Cap Inspection
- Cooling System Cap
- Cooling System Service Warnings
- Cooling System
- Electrical Fan Control
- Engine Coolant Leakage Inspection
- Engine Coolant Level Inspection
- Engine Coolant Protection Inspection
- Engine Coolant Replacement
- Engine Coolant Temperature (ECT) Sensor Inspection
- Engine Coolant Temperature (ECT) Sensor Removal/Installation
- Engine Coolant Temperature (ECT) Sensor
- Fan Switch Inspection [Manual Air Conditioner]
- Fuel Gauge Sender Unit Inspection [2 Wd]
- Fuel Gauge Sender Unit Inspection [Awd]
- Fuel Gauge Sender Unit Removal/Installation [2 Wd]
- Fuel Gauge Sender Unit Removal/Installation [Awd]
- Low Engine Coolant Temperature Indicator Light (Blue)/High Engine Coolant Temperature Warning Light (Red)
- Radiator Removal/Installation
- Radiator
- Shroud Panel Removal/Installation
- Shroud Side Member Installation [Panel Replacement]
- Shroud Side Member Removal [Panel Replacement]
- Shroud Upper Member Removal/Installation
- Shroud Upper Reinforcement Installation [Panel Replacement]
- Shroud Upper Reinforcement Removal [Panel Replacement]
- Water Pump Removal/Installation
- Water Pump
- Cooling Fan Relay
- Thermostat Inspection
- Thermostat Removal/Installation
- Thermostat
Mass Air Flow (MAF) Sensor/Intake Air Temperature (Iat) Sensor No.1 Removal/Installation
NOTE:
Because the IAT sensor No.1 is integrated in the MAF sensor, replacing the
IAT sensor No.1 includes replacement of the MAF sensor/IAT sensor No.1.
1. Disconnect the negative bat ...
Coolant Reserve Tank Removal/Installation
1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.
1
Wiring harness
2
Hose
3
...
Other materials:
Fuel Tank Pressure Sensor
Purpose/Function
The fuel tank pressure sensor detects the fuel tank pressure.
Fuel tank pressure sensor is only used for OBD.
Construction
The fuel tank pressure sensor is equipped to the charcoal canister.
A piezoelectric-type sensor has been adopted.
...
Rear Bumper Reinforcement Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Rear splash shield.
b. Rear combination light.
c. Rear bumper.
3. Remove the hanger rubber in the direction of the arrow (1) shown in the figure.
4. Remove nuts.
CAUTION:
Removing the rear bumper ...
Power Supply Switching
Outline
By pressing the push button start, switching of the power supply is performed.
Function
The start stop unit switches the power supply according to the vehicle conditions
such as the selector lever (ATX)/shift lever (MTX) position and the pedal depression/release
whe ...
