Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Control Valve Body Removal/Installation [Fw6 A EL, Fw6 Ax EL]

Mazda CX-5 Service & Repair Manual / Drivetrain / Transmission/Transaxle / Automatic / Control Valve Body Removal/Installation [Fw6 A EL, Fw6 Ax EL]

On-Vehicle Removal

WARNING:

CAUTION:

1. Select the selector lever to P position.

2. Disconnect the negative battery cable..

3. Remove the front under cover No.2..

4. Clean the transaxle exterior throughout with a steam cleaner or cleaning solvents.

5. Remove the air cleaner component..

6. Disconnect the control valve body connector.


CAUTION:

7. Remove the hose clamp.


8. Drain the ATF..

9. Remove the oil pan.

CAUTION:

10. Remove the oil strainer.


11. Remove the oil strainer O-ring.


12. Remove the control valve body.

CAUTION:


13. Remove the oil seal (control valve body)..

14. Remove the gasket from the transaxle case.


On-Vehicle Installation

1. Install the gasket to the transaxle case.


2. Install the dowel pin to the control valve body.

NOTE:


3. Install the control valve body so that the parking assist lever component is engaged in the gap between the two surfaces of the spool part of the manual valve.

CAUTION:


4. Move the manual valve in both directions of the arrow and verify that the manual valve is correctly connected to the parking assist lever component and the slider pin for the range sensor.


NOTE:

5. Install the oil strainer O-ring.

NOTE:


6. Install the oil strainer.


7. Apply a light coat of silicon sealant (TB1217E) to the contact surfaces of the oil pan and transaxle case.


CAUTION:

8. Install the oil pan with new bolts before the applied sealant starts to harden.

9. Install the front under cover No.2..

10. Install the oil seal (control valve body)..

11. Install a new hose clamp to the position shown in the figure.

CAUTION:

12. Connect the control valve body connector.


CAUTION:

13. Add the ATF..

14. Install the air cleaner component..

15. Connect the negative battery cable..

16. Perform the “TCM configuration” (Control valve body Replacement)..

17. Perform the “Initial Learning” (Control valve body Replacement)..

18. Perform the “Mechanical System Test”..

19. Perform the “Road Test”..

Automatic Transaxle Warning Light [Fw6 A EL, Fw6 Ax EL]
Purpose/Function The automatic transaxle warning light illuminates when the transaxle has malfunction. Construction The automatic transaxle warning light is built into the instr ...

Control Valve Body [Fw6 A EL, Fw6 Ax EL]
Purpose/Function A direct linear solenoid has been adopted for the solenoid valve which contributes to improved shift response, drive feel and reduced shift shock by the improved precisio ...

Other materials:

Oil Control Valve (OCV) [Skyactiv G 2.0]
Purpose, Function The OCV switches the oil passage to the hydraulic variable valve timing actuator to control the opening/closing period of the exhaust valve. Construction The OCV is installed to the exhaust camshaft cap (No.1). The OCV consists of a spool valve wh ...

Driveline/Axle Abbreviations
AAS Active Adaptive Shift ABS Antilock Brake System ABDC After Bottom Dead Center ACC Accessories AFS Adaptive Front Lighting System ALC ...

High Pressure Fuel Pump Control
Outline Changes the fuel pressure applied to the fuel injector according to engine operation conditions to improve engine output and startability. The PCM determines the fuel pressure value corresponding to the engine operation conditions based on the each input signal, and driv ...

© 2016-2022 Copyright www.mcx5.org