The following components of the air bag systems are monitored by a diagnostic system:
• Crash sensors, and diagnostic module (SAS
unit)
• Front air bag sensors
• Air bag modules
• Side crash sensors
• Air bag/Front seat belt pretensioner system
warning light
• Front seat belt pretensioners
• Related wiring
(With Driver and Front Passenger Occupant Classification System)
• Front passenger air bag deactivation indicator
light
• Driver seat slide position sensor
• Front passenger seat weight sensors
• Front passenger seat weight sensor control
module
• Front passenger seat belt buckle switches
The diagnostic module continuously monitors the system's readiness. This begins when the ignition is switched ON and continues while the vehicle is being driven.
Driver and Front Passenger Occupant Classification System
Before DrivingAirflow Mode Main Link Removal/Installation
Full-auto Air Conditioner
1. The airflow mode main link is installed to the airflow mode actuator. When
removing the airflow mode main link, refer to the airflow mode actuator removal/installation..
Manual Air Conditioner
1. Disconnect the negative battery cable..
2. Remove the glove compar ...
Rear ABS Wheel Speed Sensor Removal/Installation
1. Remove the trunk board..
2. Remove the trunk end trim..
3. Remove the rear scuff plate..
4. Remove the trunk side trim..
5. Disconnect the rear ABS wheel-speed sensor connector.
6. Press the rear ABS wheel-speed sensor tabs and press out the sensor toward
the outside of the vehicl ...
Rear Buckle Removal/Installation
1. Switch the ignition to off.
2. Disconnect the negative battery cable and wait for 1 min or more..
3. Press the release switch, then disconnect the rear center seat belt and rear
buckle.
4. Fold down the rear seat back.
5. Remove the trunk board..
6. Remove the bolt.
7. Remo ...