Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Clutch Pedal Removal/Installation [C66 M R]

Mazda CX-5 Service & Repair Manual / Drivetrain / Transmission/Transaxle / Manual / Clutch Pedal Removal/Installation [C66 M R]

CAUTION:

Removal

1. Disconnect the negative battery cable..

2. Remove the air cleaner component. (ex: air cleaner, air hose).

3. Remove the battery component. (ex: battery, battery tray and PCM component).

4. Remove the clutch pedal position switch..

5. Remove the starter interlock switch..

6. Remove the joint cover..

7. Disconnect the steering shaft from steering gear..

8. Disconnect the clutch pipe and hose No.1 from clutch master cylinder, and plug it to avoid clutch fluid leakage..

9. Disconnect the clutch reserve hose from clutch master cylinder, and plug it to avoid clutch fluid leakage..

10. Remove in the order indicated in the table.



1

Nut

2

Clutch master cylinder

(See CLUTCH MASTER CYLINDER REMOVAL/INSTALLATION [C66M-R].)

3

Clutch pedal

4

Pedal pad


Installation

1. Install in the order indicated in the table.



1

Pedal pad

2

Clutch pedal

3

Clutch master cylinder

(See CLUTCH MASTER CYLINDER REMOVAL/INSTALLATION [C66M-R].)

4

Nut


2. Connect the clutch reserve hose to clutch master cylinder..

3. Connect the clutch pipe and hose No.1 to clutch master cylinder..

4. Connect the steering shaft..

5. Install the joint cover..

6. Bleed the air from the clutch system..

7. Inspect the clutch pedal..

8. Install a new starter interlock switch..

9. Install a new clutch pedal position switch..

10. Install the battery component. (ex: battery, battery tray and PCM component).

11. Install the air cleaner component. (ex: air cleaner, air hose).

12. Connect the negative battery cable..

13. Fully depress the clutch pedal, and verify that the engine starts.

Clutch Pedal Position Switch Removal/Installation [C66 M R]
1. Disconnect the negative battery cable.. 2. Disconnect the clutch pedal position switch connector. 3. Rotate the clutch pedal position switch 45° counterclockwise. 4. Remove the clutch pe ...

Clutch Pipe And Hose Removal/Installation [C66 M R]
CAUTION: Do not allow clutch fluid to get on a painted surface. Clutch fluid contains properties which can dissolve the paint. If clutch fluid gets on a painted surface, wash it off with ...

Other materials:

Auto Leveling Sensor
Purpose Detects the vehicle height and outputs it to the AFS control module. Function Changes the detected vehicle height into a voltage value and outputs it to the AFS control module. Construction Installed to the rear cross member. Consists of link No. 1 ...

Oil Cooler
Purpose, Function The oil cooler routes engine oil and engine coolant through the interior and disperses the engine oil heat using the engine coolant. As a result, the oil temperature is maintained properly to reduce the engine oil deterioration. Construction A 9-layered ty ...

Front Accessory Socket Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the front console.. 3. Insert a tape-wrapped flathead screwdriver into the gap between the cap tab and socket. 4. Move the flathead screwdriver in the direction of the arrow (1) shown in the figure, press the front accessory socket i ...

© 2016-2022 Copyright www.mcx5.org