CAUTION:
Secure the steering wheel using tape or a cable to prevent the steering shaft from rotating after disconnecting the steering shaft. If the steering wheel rotates after the steering shaft and the steering gear and linkage are disconnected, the internal parts of the clock spring could be damaged.
Do not allow clutch fluid to get on a painted surface. Clutch fluid contains properties which can dissolve the paint. If clutch fluid gets on a painted surface, wash it off with water immediately and wipe the area off completely.
Removal
1. Disconnect the negative battery cable..
2. Remove the air cleaner component. (ex: air cleaner, air hose).
3. Remove the battery component. (ex: battery, battery tray and PCM component).
4. Remove the clutch pedal position switch..
5. Remove the starter interlock switch..
6. Remove the joint cover..
7. Disconnect the steering shaft from steering gear..
8. Disconnect the clutch pipe and hose No.1 from clutch master cylinder, and plug it to avoid clutch fluid leakage..
9. Disconnect the clutch reserve hose from clutch master cylinder, and plug it to avoid clutch fluid leakage..
10. Remove the clutch master cylinder using the following procedure:
a. Remove the clutch pedal and the clutch master cylinder as a single unit.
b. Rotate the clutch master cylinder in the direction of the arrow shown in the figure to disconnect the clutch master cylinder (body) and clutch pedal.
c. Disengage the tabs of the push rod and remove the master cylinder.
Installation
1. Install the clutch master cylinder using the following procedure:
a. Engage the tabs of the push rod with the clutch pedal as shown in the figure.
b. Rotate the clutch master cylinder in the direction shown until it stops.
c. Install the clutch pedal and the clutch master cylinder as a single unit.
2. Connect the clutch reserve hose to clutch master cylinder..
3. Connect the clutch pipe and hose No.1 to clutch master cylinder..
4. Connect the steering shaft..
5. Install the joint cover..
6. Bleed the air from the clutch system..
7. Inspect the clutch pedal..
8. Install a new starter interlock switch..
9. Install a new clutch pedal position switch..
10. Install the battery component. (ex: battery, battery tray and PCM component).
11. Install the air cleaner component. (ex: air cleaner, air hose).
12. Connect the negative battery cable..
13. Fully depress the clutch pedal, and verify that the engine starts.
Shift Position Indicator Light [Fw6 A EL, Fw6 Ax EL]
Purpose/Function
The shift position indicator light indicates the selector lever position.
Construction
The shift position indicator light is built into the instrument cluster.
Operation
The TCM sends a shift position indicator light illumination request signal ...
Initial Learning [Fw6 A EL, Fw6 Ax EL]
Introduction
If the control valve body and oil pressure switch are replaced, always perform
the initial learning. If the initial learning is not completed, engine rev-up
may occur or shift shock may increase. DTC P06B8:00 is displayed while the initial
learning has not been implement ...
Non Return Valve Inspection
WARNING:
Fuel is very flammable liquid. If fuel spills or leaks from the pressurized
fuel system, it will cause serious injury or death and facility breakage. Fuel
can also irritate skin and eyes. To prevent this, always complete the “Fuel
Line Safety Procedure”, while referring ...