CAUTION:
Do not allow clutch fluid to get on a painted surface. Clutch fluid contains properties which can dissolve the paint. If clutch fluid gets on a painted surface, wash it off with water immediately and wipe the area off completely.
Do not mix different types of clutch fluid, otherwise the clutch may not operate normally.
Do not reuse old clutch fluid, otherwise the clutch may not operate normally.
NOTE:
A common reserve tank is used for the clutch system and brake system.
1. Remove the front under cover No.2..
2. Remove the reserve tank cap.
3. Drain the clutch fluid from bleeder screw.
4. Add new clutch fluid to the MAX mark of the reserve tank.
SAE J1703 or FMVSS116 DOT-3
5. Bleed the air from the clutch system.
CAUTION:
Keep the clutch fluid level in the reserve tank at 3/4 full or more during air bleeding.
a. Connect a vinyl tube to the bleeder screw.
b. Place the other end of the vinyl tube in a clear container, and fill clutch fluid in the container during air bleeding.
c. Working with two people, one loosens the bleeder screw.
d. The other person depresses the clutch pedal to full stroke taking approx. 3 s or more, and then holding the pedal depressed.
e. After waiting approx. 5 s or more, tighten the bleeder screw.
f. Return the clutch pedal slowly taking 3 s or more while suppressing the spring force.
g. Wait approx. 5 s or more.
h. Continue to perform air bleeding (Steps (3) - (7)) until no air comes from the vinyl tube.
i. Fill the reserve tank to MAX mark with the clutch fluid.
SAE J1703 or FMVSS116 DOT-3
6. Install the reserve tank cap.
7. Install the front under cover No.2..
Parking in an Emergency
Parking in an Emergency
The hazard warning lights should always be used when you stop on or near a roadway
in an emergency.
The hazard warning lights warn other drivers that your vehicle is a traffic hazard
and that they must take extreme caution when near it.
Depress the hazard warning fla ...
Power Window Motor Inspection
Front driver side
1. Disconnect the negative battery cable..
2. Remove the inner garnish..
3. Remove the front door trim..
4. Disconnect the power window motor connector.
5. Apply battery positive voltage and connect the ground to power window motor
terminals E and F, and then inspect the ...
Rear Drive Shaft
Purpose, Function
Engine noise and vibration have been reduced due to adoption of a bell joint
on the wheel side of the constant velocity joint.
A low noise and vibration double offset joint with low slide resistance has
been adopted for the differential side of the constant v ...