Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Clock Removal/Installation

1. Disconnect the negative battery cable..

2. Remove the following parts:

a. Shift lever knob (MTX).

b. Front console box.

c. Shift panel.

d. Upper panel.

e. Rear console.

f. Side wall.

g. Decoration panel.

h. Front console.

i. Glove compartment.

j. Climate control unit.

3. Push out the clock in the direction of the arrow (2) shown in the figure while pressing clip A in the direction of the arrow (1) shown in the figure, and detach clip A and the climate control unit.


4. Push out the clock in the direction of the arrow (4) shown in the figure while pressing the clock tab in the direction of the arrow (3) shown in the figure and remove the clock tab and climate control unit.


5. Push out the clock in the direction of the arrow (6) shown in the figure while pressing clip B in the direction of the arrow (5) shown in the figure, detach the clock tab and climate control unit, and remove the clock from the climate control unit.


6. Install in the reverse order of removal.

Clock Inspection
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Shift lever knob (MTX). b. Front console box. c. Shift panel. d. Upper panel. e. Rear console. f. Side wall. ...

Clock Spring Adjustment [Standard Deployment Control System]
1. Set the front wheels straight ahead. CAUTION: The clock spring will break if over?wound. Do not forcibly turn the clock spring. 2. Turn the clock spring clockwise until it stops. ...

Other materials:

Rear Fender Panel Removal [Panel Replacement]
Symbol Mark Removal Procedure CAUTION: Avoid cutting with a blowtorch or similar tools as the insulator (shaded area) is flammable. 1. Rough cut the 3 locations indicated by (A) shown in the figure. 2. Drill the 90 locations indicated by (B) shown in the figure. ...

Warm Up Three Way Catalytic Converter (Wu Twc) Inspection
CAUTION: Perform the following procedures, DTC P0421:00 is indicated only. 1. Connect the M-MDS to the DLC-2. 2. Start the engine and warm it up to normal operating temperature. 3. Turn off the engine. 4. Verify that the engine compression is within the specification.. If ...

Air Bag System Service Warnings [Two Step Deployment Control System]
Air Bag Module Inspection Inspecting an air bag module using a tester can operate (deploy) the air bag module, which may cause serious injury. Do not use a tester to inspect an air bag module. Always use the on-board diagnostic function to diagnose the air bag module for malfunctions ...

© 2016-2022 Copyright www.mcx5.org