Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Climate Control Unit Removal/Installation [Manual Air Conditioner]

Mazda CX-5 Service & Repair Manual / HVAC / A/C / Climate Control Unit Removal/Installation [Manual Air Conditioner]

Removal

1. Disconnect the negative battery cable..

2. Remove the following parts:

a. Shift lever knob (MTX).

b. Glove compartment.

c. Front console box.

d. Shift panel.

e. Upper panel.

f. Rear console.

g. Side wall.

h. Decoration panel.

i. Front console.

3. Press the tab down, then slide the wire off the link.


4. Remove the wire from the wire clamp.

5. Remove in the order indicated in the table.



1

Screw

2

Connector

3

Climate control unit


6. Pull out the air mix wire and airflow mode wire from the dashboard.


Install

1. Pass each wire through the hole on the dashboard as shown in the figure.


2. Route each wire as shown in the figure.


3. Install in the order indicated in the table.



1

Connector

2

Climate control unit

3

Screw


4. Connect each wire to links and install it to the wire clamps.


5. Verify that the dial operation is correct by fully turning each of the dials from one end to the other.

6. Install the following parts:

a. Front console.

b. Decoration panel.

c. Side wall.

d. Rear console.

e. Upper panel.

f. Shift panel.

g. Front console box.

h. Glove compartment.

i. Shift lever knob (MTX).

7. Connect the negative battery cable..

Climate Control Unit Removal/Installation [Full Auto Air Conditioner]
NOTE: The climate control unit prior to replacement stores the vehicle specification information. The new climate control unit does not store any vehicle specification information. ...

Climate Control Unit [Manual Air Conditioner]
Purpose The climate control unit performs air conditioning according to the operation by the users and the driving conditions of the vehicle. Function The climate control unit d ...

Other materials:

Audio Unit Removal/Installation
Removal 1. Disconnect the negative battery cable. 2. Remove the decoration panel.. 3. Remove the bolt. 4. Remove the screws. NOTE: When removing the audio unit, the audio unit could interfere with the climate control unit and scratch the climate control unit. Perform the serv ...

Turn Signal/Hazard Warning Indicator Lights
Purpose Notifies the driver that a turn light, the hazard warning lights are flashing. Function Flashes according to the turn switch and hazard warning switch operations. Construction Displayed in the instrument cluster. Operation Turn system 1. When th ...

Procedure [Plastic Body Parts]
Repair of polypropylene bumpers having damage that has reached the surface of the polypropylene and are too serious to be restored by painting only. 1. Cut the rough edges around the damage with a knife to make it smooth. Sand the area with a sander to make an angle of about 45°. 2. ...

© 2016-2026 Copyright www.mcx5.org