Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Center Roof Antenna Removal/Installation

Mazda CX-5 Service & Repair Manual / Accessories / Electronics / Entertainment / Center Roof Antenna Removal/Installation

1. Disconnect the negative battery cable..

2. Remove the following parts:

a. Front scuff plate.

b. Rear scuff plate.

c. B-pillar lower trim.

d. Front seat belt adjusting cover.

e. Front seat belt upper anchor installation bolt.

f. B-pillar upper trim.

g. Trunk board.

h. Trunk end trim.

i. Trunk side trim.

j. D-pillar trim.

k. C-pillar trim.

3. Remove the rear passenger's assist handle..

4. Partially peel back the headliner.

CAUTION:

5. Disconnect the connector.


6. Remove the nut.

7. While pressing the center roof antenna tabs in the direction of arrows (1) shown in the figure, press the center roof antenna in the direction of arrow (2) to detach the center roof antenna tabs from the body.


8. Remove the center roof antenna.

9. Install in the reverse order of removal.

Center Roof Antenna Inspection
NOTE: The center roof antenna is integrated with the antenna amplifier. Antenna amplifier inspection 1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Fro ...

Coil Antenna
Purpose Sends the ID data programmed to the electronic transmission device (transponder) in the remote transmitter to the start stop unit. Function A magnetic field occurs aroun ...

Other materials:

Pre Tensioner Seat Belt [Standard Deployment Control System]
Purpose The pre-tensioner seat belt retracts and tightens the seat belt webbing to protect the front passengers during a collision. Function The pre-tensioner seat belts operate (deploy) based on the operation signal from the SAS control module to instantly retract and tigh ...

Airflow Mode Actuator [Full Auto Air Conditioner]
Purpose The airflow mode actuator moves the mode door in the A/C unit to switch the air vent. Function Door open/close function The airflow mode actuator drives the motor based on the signal from the climate control unit and moves the mode door to the VENT, BI-LEVEL, HEAT, ...

Blind Spot Monitoring (Bsm) Off Indicator Light
Purpose The BSM OFF indicator light informs the driver that the Blind Spot Monitoring (BSM) system is turned off or there is a malfunction in the system. Function The instrument cluster illuminates the BSM OFF indicator light based on the BSM system off signal sent via a CA ...

© 2016-2025 Copyright www.mcx5.org