Purpose, Function
Purifies contaminants in the exhaust gas by utilizing the chemical reactions of the three-way catalytic converter.
A WU-TWC and a TWC have been adopted.
The three-way catalyst is integrated with the exhaust manifold.
Because the catalyst receives the high temperature exhaust gas just after the gas is exhausted, it activates quickly and achieves an improved purification performance.
A single-nano catalyst has been adopted in which the purification performance can be maintained using less precious metal materials than conventional catalysts.
Construction
WU-TWC
The WU-TWC is installed to the rear of the engine.
The WU-TWC is integrated with the exhaust manifold.
TWC
The TWC is installed to the rear of the WU-TWC.
2WD
AWD
A single-nano catalyst has been adopted for the under-floor three-way catalyst. With a conventional three-way catalyst, the precious metals move and agglutinate to each other by the heat of the exhaust gas because they are structured such that they adhere on catalyst material. Therefore, it was necessary to use a large amount of precious metal because it is estimated that the purification performance lowers due to the decrease in the surface area of the precious metals. The single-nano catalyst is structured such that it embeds small precious metal particles into the catalyst material. Because the precious metal particles do not agglutinate on the surface of the three-way catalyst, it can maintain superior purification performance using less precious metal than the conventional system.
Operation
Contaminants in the exhaust gas (HC, CO, NOx) are purified by oxidization and deoxidization while they are passing through the catalytic converter.
Oxidization process
Noxious hydrocarbon (HC) and carbon monoxide (CO) are bound with oxygen and converted to non-noxious carbon dioxide and water.
O2+HC+CO>CO2+H2O
Deoxidization process
Noxious nitrogen oxide (NOx) is converted to non-noxious nitrogen and oxygen. A part of the oxygen generated in this process is used in the oxidization process.
NOx>N2+O2
Shift Panel Removal/Installation
ATX
1. Disconnect the negative battery cable..
2. Selector lever to neutral position.
3. Remove the front console box..
4. Take the shaded area shown in the figure, and remove the shift panel in the
direction of the arrow in the order of (1), (2) while detaching clips A, hook B.
5. D ...
Brake/Taillight Bulb Removal/Installation
1. Disconnect the negative battery cable..
2. Insert a tape-wrapped flathead screwdriver into the service hole in the position
shown in the figure.
3. Move the flathead screwdriver in the direction of the arrow (1) shown in the
figure, pull out the service hole cover, and detach the serv ...
Front Seat
Purpose, Function
The front seats are structured to reduce impact force applied to the head
of the occupant in a vehicle collision.
8WAY or 6WAY power seats have been adopted on the driver's seat. (with power
seat system).
A seat warmer system has been adopted on the ...