Mazda CX-5 Service & Repair Manual: Car Navigation Unit
Purpose
-
Reads the SD card data inserted into the car-navigation unit and sends the read data to the audio unit.
Function
-
The car-navigation unit has the following functions:
TomTom Home
-
By connecting the SD card to your computer at home, the map data or software can be updated by the user.
LIVE Service
NOTE:
-
Can be used when the TomTom Live service is contracted.
-
HD traffic™
-
Safety alerts
-
Local search
-
Weather forecast
Construction
-
The car-navigation unit is installed to the driver-side lower panel.
-
The panel is integrated with the unit.
Terminal layout and signal
Antenna feeder connector
|
Terminal |
Signal |
|
|
|
1A |
Ground |
|
1B |
Ground |
|
|
1C |
Ground |
|
|
1D |
Ground |
|
|
1E |
— |
|
|
1F |
— |
|
|
1G |
ACC |
|
|
1H |
+B |
|
|
|
2A |
USB power |
|
2B |
USB data (+) |
|
|
2C |
USB GND |
|
|
2D |
USB data (+) |
|
GPS/RDS-TMC antenna
Antenna feeder connector
|
Terminal |
Signal |
|
|
|
3A |
RDS-TMC |
|
3B |
GPS |
|
Operation
-
For the car-navigation unit operation, refer to the CAR-NAVIGATION SYSTEM
Fail-safe
-
Function not equipped.
Car Navigation System Does Not Start Operation [Car Navigation System]
Possible DTC
Even if the NAVI mode is selected, the car-navigation system screen does
not display.
POSSIBLE CAUSE
NAV switc ...
Car Navigation Unit Removal/Installation
CAUTION:
The audio unit communicates with the car-navigation unit and records the
presence/non-presence of the car-navigation unit when the ignition is switched
to ACC or ON (engine off ...
Other materials:
Auto Dimming Mirror Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the screw B.
3. Remove the auto-dimming mirror in the direction of arrow (1) shown in the
figure.
4. Detach tabs while push the cover No.2 in the direction of the arrow (2) shown
in the figure, then remove the cover No.2 in the d ...
Transfer Oil Seal Replacement [Fw6 Ax EL]
Transfer oil seal (LH)
1. Drain the transfer oil..
2. Remove the transfer from the vehicle..
3. Insert a tape-wrapped flathead screwdriver into the lip area of the oil seal
(LH) as shown in the figure and remove the oil seal (LH).
4. Using the SST and a hammer, tap the new seal into pla ...
Personalization Features
The following systems can be customized.
When performing a customized setting, refer to the referenced section for
the detailed setting procedure.
Security And Locks
NOTE:
There are two types of customization procedures; one using the M-MDS and
the other using the ...
