Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Car Navigation System Does Not Operation [Car Navigation System]

Mazda CX-5 Service & Repair Manual / Accessories / Electronics / Navigation / Car Navigation System Does Not Operation [Car Navigation System]


Possible DTC

Even if the map screen is touched, the car-navigation system cannot be operated

POSSIBLE CAUSE

  • Audio unit malfunction (bad LCD panel)

  • Car-navigation unit malfunction


Diagnostic Procedure


Step

Inspection

Action

1

    DETERMINE IF MALFUNCTION CAUSE IS AUDIO UNIT LCD PANEL

  • Switch the ignition ON and launch the audio unit diagnostic assist function.

    (See DIAGNOSTIC ASSIST FUNCTION [AUDIO].)

  • Select diagnostic assist code 01 display inspection.

  • Is the display normal?

Yes

Go to the next step.

No

Replace the audio unit.

(See AUDIO UNIT REMOVAL/INSTALLATION.)

2

    DETERMINE IF MALFUNCTION CAUSE IS CAR-NAVIGATION UNIT

  • Select diagnostic assist code 16 external device connection information clearing.

  • Switch the ignition off (LOCK).

  • Switch the ignition ON (engine off or on).

  • Launch the audio unit diagnostic assist function.

    (See DIAGNOSTIC ASSIST FUNCTION [AUDIO].)

  • Select diagnostic assist code 15 vehicle NAVI signal verification.

  • Is NAVI (USB) NG displayed?

Yes

Replace the car-navigation unit.

(See CAR-NAVIGATION UNIT REMOVAL/INSTALLATION.)

No

Replace the audio unit.

(See AUDIO UNIT REMOVAL/INSTALLATION.)


Car Navigation System
Outline The car-navigation system displays point-of-origin and road guidance maps via the audio unit display and provides guidance and information to the desired point of destination. ...

Car Navigation System Does Not Start Operation [Car Navigation System]
Possible DTC Even if the NAVI mode is selected, the car-navigation system screen does not display. POSSIBLE CAUSE NAV switc ...

Other materials:

Climate Control Unit Inspection [Full Auto Air Conditioner]
1. Remove the climate control unit with the connector connected.. 2. Switch the ignition ON (engine off or on). 3. Connect the negative (-) lead of the tester to body ground. 4. By inserting the positive (+) lead of the tester into each climate control unit terminal, measure the voltage acco ...

Starter Interlock Switch Removal/Installation [C66 M R]
1. Disconnect the negative battery cable.. 2. Disconnect the starter interlock switch connector. 3. Remove the starter interlock using the following procedure: a. Detach hook A in the direction of the arrow shown in the figure. b. Slide the starter interlock switch in the direction of th ...

Rear Side Frame Installation [Panel Replacement]
Symbol Mark Installation Procedure 1. When installing new parts, measure and adjust the body as necessary to conform with standard dimensions. 2. Drill holes for the plug welding before installing the new parts. 3. After temporarily installing new parts, make sure the related parts fit p ...

© 2016-2024 Copyright www.mcx5.org