Mazda CX-5 Service & Repair Manual: Canister Vent (Cv) Solenoid Valve Inspection
U.S.A. And CANADA
Airflow inspection
1. Disconnect the negative battery cable..
2. Remove the CV solenoid valve..
3. Inspect airflow between the ports under the following conditions.
|
Measured condition |
Continuity between A—B |
|
When voltage is not applied between terminals A and B |
Airflow detected |
|
When voltage is applied between terminals A and B |
No airflow |
-
If not as specified, replace the CV solenoid valve..
-
Should assume the voltage 12V
(D.C.).
-
Terminals A and B is nonpolar.
Emissions
...
Canister Vent (Cv) Solenoid Valve Removal/Installation
U.S.A. And CANADA
1. Disconnect the negative battery cable..
2. Remove the floor under cover (LH)..
3. Disconnect the evaporative hose No.2..
4. Remove in the order indicated in the table.
...
Other materials:
Speaker [Without Bose®]
Purpose
Converts the audio signal from the audio unit to sound.
Function
Full-range speakers, which can output wide-range sound from low to high frequency,
have been adopted.
Specification
Item
Front door speaker
Rear speaker ...
Lubrication System
Outline
Pressure loss is reduced by optimizing the oil passage.
With the adoption of the chain drive type oil pump, oil pump drive force
has been reduced.
With the adoption of the oil shower pipe, sliding resistance has been reduced.
With the adoption of the engine ...
Cargo Compartment Light Removal/Installation
1. Disconnect the negative battery cable..
2. To prevent scratches or damage, affix protective tape to the position shown
in the figure.
CAUTION:
If a flathead screwdriver is inserted into the gap between the cargo compartment
light and trunk side trim, the trunk side trim could int ...
