Mazda CX-5 Service & Repair Manual: Camshaft Position (CMP) Sensor
Purpose/Function
-
Detects the camshaft speed as basic information for mainly determining the fuel injection timing and ignition timing.
-
Detects the camshaft speed and inputs it to the PCM as a CMP signal.
Construction
Intake CMP sensor
-
Installed on the cylinder head.
-
A GMR element has been adopted as the detecting element for detecting the intake camshaft speed.
Exhaust CMP sensor
-
Installed on the rear housing.
-
A GMR element has been adopted as the detecting element for detecting the exhaust camshaft speed.
Operation
-
Inputs the signal, which fluctuates according to the camshaft speed, to the PCM.
CMP sensor characteristic
Fail-safe
Intake CMP sensor
|
DTC No. |
Fail-safe function |
|
P0340:00 |
|
Exhaust CMP sensor
|
DTC No. |
Fail-safe function |
|
P0365:00 |
|
Camshaft Position (CMP) Sensor Removal/Installation
CAUTION:
When replacing the CMP sensor, make sure there is no foreign material on
it such as metal shavings. If it is installed with foreign material, the sensor
output signal will malfu ...
Camshaft
Purpose, Function
The camshaft is rotated by receiving the rotation force of the crankshaft
via the timing chain. The valve is opened and closed according to the cam shape
at this time.
...
Other materials:
Front Side Frame (Partial Cutting) Removal [Panel Replacement]
Symbol Mark
Removal Procedure
1. Drill the 4 locations indicated by (A) shown in the figure, then remove suspension
mounting reinforcement and outer frame reinforcement.
2. Rough cut location indicated by (B) shown in the figure.
3. Drill the 6 locations indicated by (C) shown in the fig ...
Rear Seat Back Striker Removal/Installation
1. Disconnect the negative battery cable..
2. Press the push knob to fold the rear seat back.
3. Remove the following parts:
a. Trunk board.
b. Trunk end trim.
c. Rear scuff plate.
d. Trunk side trim.
4. Remove the bolts.
5. Remove the rear seat back striker.
6. Install in the ...
Clutch Master Cylinder Removal/Installation [C66 M R]
CAUTION:
Secure the steering wheel using tape or a cable to prevent the steering shaft
from rotating after disconnecting the steering shaft. If the steering wheel
rotates after the steering shaft and the steering gear and linkage are disconnected,
the internal parts of the clock spr ...
