Mazda CX-5 Service & Repair Manual: Caliper (Rear) Disassembly/Assembly
1. Disassemble in the order indicated in the table.
|
1 |
Bleeder cap |
|
2 |
Bleeder screw |
|
3 |
Piston (See Piston Disassembly Note.) (See Dust Seal, Piston Assembly Note.) |
|
4 |
Dust seal (See Dust Seal, Piston Assembly Note.) |
|
5 |
Piston seal |
|
6 |
Caliper body |
2. Assemble in the reverse order of removal.
Piston Disassembly Note
1. Rotate the piston counter-clockwise using the SST
, remove the piston from the caliper body.
Dust Seal, Piston Assembly Note
1. Assemble the dust seal to the piston.
2. Assemble the lip of the dust seal to the groove of the caliper body with the dust seal is assembled to the piston as shown in the figure.
3. Rotate the piston clockwise using the SST
slowly and push the piston inwards completely.
4. Verify that the dust seal is installed into the groove of the piston securely.
Caliper (Front) Disassembly/Assembly
1. Disassemble in the order indicated in the table.
1
Bleeder cap
2
Bleeder screw
3
Piston
(See Piston Disassem ...
Front Brake (Disc)
Purpose/Function
Large diameter, ventilated disc type front brakes with a 297 mm {11.7 in}
diameter and 28 mm {1.1 in} thickness have been adopted, improving braking force
and fade resist ...
Other materials:
Mirror Base Installation
1. Cut away all of the original sealant using a razor.
WARNING:
Using a razor with bare hands can cause injury. Always wear gloves when using
a razor.
2. Clean and degrease the ceramic coating on the glass and the base.
CAUTION:
Keep the area free of dirt and grease, and ...
Brake Fluid Level Sensor Inspection
1. Disconnect the brake fluid level sensor connector from the master cylinder.
2. Inspect for continuity according to fluid level between the brake fluid level
sensor terminals.
If not as indicated in the table, replace the reserve tank..
...
Side Sill Panel Removal [Panel Replacement]
Symbol Mark
Removal Procedure
Side sill (front side)
1. Rough cut the 2 locations indicated by (A) shown in the figure.
2. Drill the 18 locations indicated by (B) shown in the figure.
3. Remove the cabin side outer frame (outer side sill).
Side sill (component)
1. Rough cut the 3 l ...
