Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Caliper (Front) Disassembly/Assembly

Mazda CX-5 Service & Repair Manual / Brakes / Disc Brakes / Caliper (Front) Disassembly/Assembly

1. Disassemble in the order indicated in the table.



1

Bleeder cap

2

Bleeder screw

3

Piston

(See Piston Disassembly Note.)

4

Dust seal

5

Piston seal

6

Caliper body


2. Assemble in the reverse order of removal.

Piston Disassembly Note

WARNING:

CAUTION:

1. Insert a piece of wood in the caliper as shown in the figure and blow compressed air through the hole to remove the piston from the caliper body.


Disc Brakes
...

Caliper (Rear) Disassembly/Assembly
1. Disassemble in the order indicated in the table. 1 Bleeder cap 2 Bleeder screw 3 Piston (See Piston Disassem ...

Other materials:

Driver and Front Passenger Occupant Classification System
First, please read “Supplemental Restraint System (SRS) Precautions”  carefully. Driver Seat Slide Position Sensor Your vehicle is equipped with a driver seat slide position sensor as a part of the supplemental restraint system. The sensor is located under the driver seat. The sensor ...

Wheel Hub, Steering Knuckle Removal/Installation
CAUTION: Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the wiring harness if it is pulled by mistake. Before performing the following procedures, disconnect the ABS wheel-speed sensor connector (axle sid ...

High Clutch [Fw6 A EL, Fw6 Ax EL]
Purpose/Function The high clutch operates in 4GR, 5GR, and 6GR and intermittently operates the rear carrier by drive force from the turbine shaft. For the high clutch, a centrifugal balance clutch has been adopted to prevent clutch drag and to assure stabilized piston thrust in ...

© 2016-2022 Copyright www.mcx5.org