Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Bumper Slider Removal/Installation

Mazda CX-5 Service & Repair Manual / Body / Body Exterior, Frame / General / Bumper Slider Removal/Installation

Front Bumper Slider

1. Disconnect the negative battery cable..

2. Remove the seal board upper..

3. Remove the front bumper..

4. Remove bolts A.


5. Pull the front bumper slider in the direction of the arrow while detaching pins B and hook C.

6. Install in the reverse order of removal.

Rear Bumper Slider

1. Disconnect the negative battery cable..

2. Remove the following parts:

a. Rear combination light.

b. Rear splash shield.

c. Rear bumper.

3. Remove screw A.


4. Remove screw B.

5. Remove nut C.

6. Pull the rear bumper slider in the direction of the arrow while detaching hook D and pin E.

7. Install in the reverse order of removal.

Bumper Bracket Removal [Panel Replacement]
Symbol Mark Removal Procedure 1. Rough cut area locations indicated by (A). 2. Grind the 6 locations indicated by (B) shown in the figure. CAUTION: When grinding 6 locations indi ...

Bumper Stiffener Lower Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Seal board upper. b. Front bumper. c. Seal plate. d. Front under cover No.1. 3. Remove bolts A. 4. Pull t ...

Other materials:

Climate Control Unit Removal/Installation [Manual Air Conditioner]
Removal 1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Shift lever knob (MTX). b. Glove compartment. c. Front console box. d. Shift panel. e. Upper panel. f. Rear console. g. Side wall. h. Decoration panel. i. Front console. 3. Press the tab down, ...

Passenger Compartment Temperature Sensor Removal/Installation [Full Auto Air Conditioner]
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Front scuff plate (driver-side). b. Front side trim (driver-side). c. Switch panel. d. Decoration panel. e. Shift lever knob (MTX). f. Front console box. g. Shift panel. h. Upper panel. i. Rear console. ...

Front Parking Brake Cable Removal/Installation
1. Remove the front console box.. 2. Remove the shift lever knob. (MTX). 3. Remove the shift panel.. 4. Remove the upper panel.. 5. Remove the rear console.. 6. Remove in the order indicated in the table. 7. Install in the reverse order of removal. 8. After installation, inspect the pa ...

© 2016-2022 Copyright www.mcx5.org