Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Brake/Taillight Bulb Removal/Installation

Mazda CX-5 Service & Repair Manual / Brakes / General / Brake/Taillight Bulb Removal/Installation

1. Disconnect the negative battery cable..

2. Insert a tape-wrapped flathead screwdriver into the service hole in the position shown in the figure.


3. Move the flathead screwdriver in the direction of the arrow (1) shown in the figure, pull out the service hole cover, and detach the service hole cover tab and trunk side trim.


4. Pull out the service hole cover in the direction of the arrow (2) shown in the figure and pull out the service hole cover hook from the trunk side trim.


5. Remove the service hole cover.

6. Rotate the socket in the direction of the arrow (3) shown in the figure and remove it from the rear combination light in the direction of the arrow (4) shown in the figure.


7. Remove the brake/taillight bulb.


8. Install in the reverse order of removal.

Brake Pedal Removal/Installation
CAUTION: The clearance between the brake switch and the brake pedal is automatically adjusted to the correct amount when the brake switch is inserted into the installation hole on the br ...

Brakes
Abbreviations AAS Active Adaptive Shift ABS Antilock Brake System ABDC After Bottom Dead Center ACC ...

Other materials:

Seat Belt Extender
If your seat belt is not long enough, even when fully extended, a seat belt extender may be available to you at no charge from your Authorized Mazda Dealer. This extender will be only for you and for the particular vehicle and seat. Even if it plugs into other seat belts, it may not hold in the ...

Ambient Temperature Sensor [Manual Air Conditioner]
Purpose The ambient temperature sensor detects the ambient temperature. Function The ambient temperature sensor converts the detected temperature to an electric signal. Construction A thermistor-type ambient temperature sensor has been adopted. The ambient ...

Roof Carrier Bracket Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Sunroof seaming welt (with sunroof system). b. A-pillar trim. c. Front map light. d. Sunvisor. e. Front scuff plate. f. Rear scuff plate. g. B-pillar lower trim. h. Adjust anchor cover. i. Upper anchor i ...

© 2016-2022 Copyright www.mcx5.org