Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Brake Hose (Front) Removal/Installation

Mazda CX-5 Service & Repair Manual / Brakes / General / Brake Hose (Front) Removal/Installation

1. Remove in the order indicated in the table.

2. Install in the reverse order of removal.

3. After installation, add brake fluid, bleed the air, and inspect for fluid leakage..



1

Brake pipe

2

Clip

3

Bolt

4

Brake hose


Brake Fluid Pressure Sensor Inspection
1. Switch the ignition to off. 2. Remove the clips. 3. Set the splash shield out of the way. 4. Disconnect the brake pipe from the LF brake hose. 5. Remove the clip. 6. Remove the LF ...

Brake Hose (Rear) Removal/Installation
1. Remove in the order indicated in the table. 2. Install in the reverse order of removal. 3. After installation, add brake fluid, bleed the air, and inspect for fluid leakage.. ...

Other materials:

Steering Angle Sensor Inspection
1. Remove the column cover.. 2. Connect the plus (+) end of a tester to steering angle sensor terminal A and the minus (-) end of the tester to terminal B (GND). 3. Switch the ignition ON (engine off or on). 4. Turn the steering wheel to the left and right. 5. Verify that the voltage f ...

Cooling Fan Motor Removal/Installation
WARNING: Never remove the cooling system cap or loosen the radiator drain plug while the engine is running, or when the engine and radiator are hot. Scalding engine coolant and steam may shoot out and cause serious injury. It may also damage the engine and cooling system. Tu ...

Air Bag Module And Pre Tensioner Seat Belt Disposal Procedures [Standard Deployment Control System]
WARNING: A live (undeployed) air bag module or pre-tensioner seat belt may accidentally operate (deploy) when it is disposed of and cause serious injury. Always refer to the “AIR BAG MODULE AND PRE-TENSIONER SEAT BELT DEPLOYMENT PROCEDURES” and dispose of air bag modules a ...

© 2016-2022 Copyright www.mcx5.org