Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Brake Fluid Pressure Sensor

Mazda CX-5 Service & Repair Manual / Brakes / General / Brake Fluid Pressure Sensor

Purpose/Function

Construction

Fail-safe


DTC No.

Fail-safe function

C0044:01

  • Illuminates the TCS/DSC indicator light.

  • Tire pressure monitoring system warning light illuminates after flashes. (Not illuminated/flashed depending on malfunction content.)

  • Inhibits the TCS*, DSC*, roll over mitigation (ROM)*, brake assist control, hill launch assist (HLA)*, and TPMS* controls.

C0044:28

  • Illuminates the TCS/DSC indicator light.

  • Tire pressure monitoring system warning light illuminates after flashes.

  • Inhibits the TCS, DSC, roll over mitigation (ROM), brake assist control, hill launch assist (HLA), and TPMS controls.

C0044:54

C0044:64

  • Illuminates the TCS/DSC indicator light.

  • Tire pressure monitoring system warning light illuminates after flashes. (Not illuminated/flashed depending on malfunction content.)

  • Inhibits the TCS*, DSC*, roll over mitigation (ROM)*, brake assist control*, hill launch assist (HLA)*, and TPMS* controls.


* Enabled depending on malfunction content.

Brake Fluid Inspection
1. Verify that the brake fluid level in the brake fluid reserve tank is between the MAX and MIN marks. If the brake fluid level is below the MIN mark, add brake fluid. ...

Brake Fluid Pressure Sensor Inspection
1. Switch the ignition to off. 2. Remove the clips. 3. Set the splash shield out of the way. 4. Disconnect the brake pipe from the LF brake hose. 5. Remove the clip. 6. Remove the LF ...

Other materials:

Clock Input/Output Check Mode
Activation procedure Inspection NOTE: The clock input/output check mode is displayed in the following order and returning to the previous screen is impossible. If you want to check All LCD illuminated or Check code 1 or 2 after Check code 6 is displayed, activate the inpu ...

Control System [Manual Air Conditioner]
Outline Refrigerant pressure sensor adopted in which refrigerant pressure is changed into a linear electric signal and precise information is transmitted. Climate control unit with enlarged operation dials and switches adopted Structural View System Wiring Diagram ...

Rear Door Trim Removal/Installation
1. Insert a tape-wrapped flathead screwdriver in the position indicated by the arrow (1) in the figure and remove the inner handle cover while detach tabs A, pin B. 2. Remove the screw C. 3. Remove the cover D, then remove the screw E. 4. Take the shaded area shown in the figur ...

© 2016-2026 Copyright www.mcx5.org