Mazda CX-5 Service & Repair Manual: Brake Fluid Pressure Sensor

Mazda CX-5 Service & Repair Manual / Engine / Emissions / Brake Fluid Pressure Sensor

Purpose/Function

The brake fluid pressure sensor detects the fluid pressure from the master cylinder and transmits it to the DSC HU/CM.

Construction

The brake fluid pressure sensor is built into the DSC HU/CM. Therefore if there is any malfunction of the brake fluid pressure sensor, replace the DSC HU/CM.

Fail-safe


DTC No.	Fail-safe function
C0044:01	Illuminates the TCS/DSC indicator light. Tire pressure monitoring system warning light illuminates after flashes. (Not illuminated/flashed depending on malfunction content.) Inhibits the TCS, DSC, roll over mitigation (ROM), brake assist control, hill launch assist (HLA), and TPMS* controls.
C0044:28	Illuminates the TCS/DSC indicator light. Tire pressure monitoring system warning light illuminates after flashes. Inhibits the TCS, DSC, roll over mitigation (ROM), brake assist control, hill launch assist (HLA), and TPMS controls.
C0044:54
C0044:64	Illuminates the TCS/DSC indicator light. Tire pressure monitoring system warning light illuminates after flashes. (Not illuminated/flashed depending on malfunction content.) Inhibits the TCS, DSC, roll over mitigation (ROM), brake assist control, hill launch assist (HLA), and TPMS controls.

* Enabled depending on malfunction content.

Warm Up Three Way Catalytic Converter (Wu Twc) Inspection

CAUTION: Perform the following procedures, DTC P0421:00 is indicated only. 1. Connect the M-MDS to the DLC-2. 2. Start the engine and warm it up to normal operating temperature. 3. T ...

Brake Fluid Pressure Sensor Inspection

1. Switch the ignition to off. 2. Remove the clips. 3. Set the splash shield out of the way. 4. Disconnect the brake pipe from the LF brake hose. 5. Remove the clip. 6. Remove the LF ...

Other materials:

Air Bag System [Two Step Deployment Control System]
Outline The air bag system is a device that supplements the passenger restraint function of the seat belts. The air bag system will not have the designed effect if the seat belts are not worn properly. The air bag system is composed of the following parts: ...

AUX/USB/iPod mode
Audio can be heard from the vehicle's speakers by connecting a commercially available portable audio unit to the auxiliary jack. A commercially-available, non-impedance (3.5 ) stereo mini plug cable is required. Contact an Authorized Mazda Dealer for details. In addition, audio can be playe ...

Antenna Feeder No.2 Inspection
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. A-pillar trim (RH). b. Trunk board. c. Trunk end trim (RH). d. Rear scuff plate (RH). e. Trunk side trim (RH). 3. Disconnect antenna feeder No.1. 4. Disconnect antenna feeder No.3. 5. Verify that t ...