Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Brake Fluid Air Bleeding

Mazda CX-5 Service & Repair Manual / Brakes / General / Brake Fluid Air Bleeding

CAUTION:

NOTE:

1. Remove the cap from the brake fluid reserved tank and add brake fluid.

2. Remove the bleeder cap on the brake caliper, and attach a vinyl tube to the bleeder screw.

3. Place the other end of the vinyl tube in a clear container and fill the container with fluid during air bleeding.

4. Working with two people, one should pump the brake pedal several times and depress and hold the pedal down.

5. While the brake pedal is depressed, the other should loosen the bleeder screw using a commercially available flare nut wrench, drain out any fluid containing air bubbles, and tighten the bleeder screw.


6. Repeat Steps 4 and 5 until no air bubbles are seen.

7. Perform air bleeding as described in the above procedures for all brake calipers.

8. Clean the brake calipers.

9. After air bleeding, inspect the following:

2 6 Brake [Fw6 A EL, Fw6 Ax EL]
Purpose/Function The 2-6 brake locks the rear internal gear and reduction planetary carrier while in 2GR and 6GR. Construction The 2-6 brake consists of the following parts show ...

Brake Fluid Inspection
1. Verify that the brake fluid level in the brake fluid reserve tank is between the MAX and MIN marks. If the brake fluid level is below the MIN mark, add brake fluid. ...

Other materials:

Fuel Tank Pressure Sensor
Purpose/Function The fuel tank pressure sensor detects the fuel tank pressure. Fuel tank pressure sensor is only used for OBD. Construction The fuel tank pressure sensor is equipped to the charcoal canister. A piezoelectric-type sensor has been adopted. ...

Headlight High Beam Indicator Light
Purpose Notifies the user that the headlights (HI) are illuminated. Function Illuminates when the headlight (HI) or parking illumination conditions are met. Construction Displayed in the instrument cluster. Operation 1. When the light switch is operat ...

Front Fog Light Switch Inspection
1. Disconnect the negative battery cable.. 2. Remove the column cover.. 3. Remove the light switch.. 4. Verify that the continuity between the light switch terminals is as indicated in the table. If not as indicated in the table, replace the light switch. ...

© 2016-2022 Copyright www.mcx5.org