Mazda CX-5 Owners Manual: Body Lubrication
All moving points of the body, such as door and hood hinges and locks, should be lubricated each time the engine oil is changed. Use a nonfreezing lubricant on locks during cold weather.
Make sure the hood's secondary latch keeps the hood from opening when the primary latch is released.
Washer Fluid
InspectingWasher Fluid Level
WARNING
Use only windshield washer fluid or plain water in the reservoir:
Using radiator antifreeze as washer fluid is dangerous. If sprayed on the windshield,
it wil ...
Wiper Blades
CAUTION
●Hot waxes applied by automatic car washers
have been known to affect the wiper's ability to clean windows.
● To prevent damage to the wiper blades,
do not use gasoline, ...
Other materials:
Purge Solenoid Valve Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the plug hole plate..
3. Remove the air cleaner and air hose as a single unit..
4. Disconnect the high pressure fuel pump connector.
5. Disconnect the harness clip as shown in the figure.
6. Remove in the order indicated in the table ...
Speaker Grille Removal/Installation
Center Speaker Grille
1. Insert a tape-wrapped flathead screwdriver into shown in the figure and remove
hooks A in the direction of arrow (1).
2. Take the shaded area shown in the figure, and remove the center speaker grille
in the direction of arrow (2) while detaching hooks B.
3. ...
Pressure Control Solenoid [Fw6 A EL, Fw6 Ax EL]
Purpose/Function
The pressure control solenoid adjusts the pressure control solenoid pressure
and controls the line pressure based on the control signal from the TCM.
Construction
The pressure control solenoid is installed to the solenoid control valve
body.
The pre ...
