Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Body Exterior, Frame

Mazda CX-5 Service & Repair Manual / Body / Body Exterior, Frame

Rear Door Trim Removal/Installation
1. Insert a tape-wrapped flathead screwdriver in the position indicated by the arrow (1) in the figure and remove the inner handle cover while detach tabs A, pin B. 2. Remove the screw C. ...

General
...

Other materials:

Rear Stabilizer Removal/Installation [Awd]
WARNING: Verify that the rear crossmember is securely supported by a jack. If the rear crossmember falls off, it can cause serious injury or death, and damage to the vehicle. CAUTION: Performing the following procedures without first removing the rear ABS wheel-speed s ...

ABS Wheel Speed Sensor And ABS Sensor Rotor
Purpose/Function The ABS wheel-speed sensor and ABS sensor rotor detect the rotation condition of each wheel and transmit this information to the DSC HU/CM. The signal from the ABS wheel-speed sensor is the primary signal that the DSC HU/CM uses when carrying out control. ...

Mass Air Flow (MAF) Sensor/Intake Air Temperature (Iat) Sensor No.1 Removal/Installation
NOTE: Because the IAT sensor No.1 is integrated in the MAF sensor, replacing the IAT sensor No.1 includes replacement of the MAF sensor/IAT sensor No.1. 1. Disconnect the negative battery cable.. 2. Disconnect the MAF sensor/IAT sensor No.1 connector. 3. Remove the MAF sensor/IA ...

© 2016-2022 Copyright www.mcx5.org