Mazda CX-5 Service & Repair Manual: Body And Accessories SST

Abbreviations

AAS Active Adaptive Shift ABS Antilock Brake System ABDC After Bottom Dead Center ACC Access ...

Front Wiring Harness Protector Removal/Installation

Front Wiring Harness Protector No.1 1. Disconnect the negative battery cable.. 2. Remove the air cleaner case.. 3. While pressing the tabs of clip A in the direction of the arrows (1) shown in ...

Other materials:

Clock Spring Removal/Installation [Two Step Deployment Control System]
CAUTION: If the disc on the combination switch is deformed or has foreign material adhering to it, performance of the steering angle sensor may be reduced, causing abnormal operation. When handling the clock spring, be careful not to deform the disc and make sure there is no foreign ...

Heater Hose Removal/Installation
With Water Temperature Sensor 1. Remove the battery.. 2. Drain the engine coolant.. 3. Remove the insulator. 4. Remove the clips and remove the heater hose. 5. Remove the heater hose. 6. Install in the reverse order of the removal. 7. Inspect for engine coolant leaka ...

Front Scuff Plate Removal/Installation
1. Take the shaded area shown in the figure, detach tab A while pulling the front scuff plate in the direction of the arrow (1) shown in the figure, then detach the hook B, clip C, and pin D while pulling in the direction of the arrow (2). 2. Take the shaded area shown in the figure, detach ta ...