Mazda CX-5 Service & Repair Manual: Blower Unit Disassembly/Assembly
CAUTION:
-
Apply only the specified grease to the link. Otherwise abnormal noise or improper operation may result.
1. Disassemble in the order indicated in the table.
|
1 |
Air filter |
|
2 |
Harness |
|
3 |
Blower motor |
|
4 |
Cover |
|
5 |
Air intake actuator |
|
6 |
Air intake link |
|
7 |
Polyurethane (1) |
|
8 |
Polyurethane (2) |
|
9 |
Polyurethane (3) |
|
10 |
Blower case (1) |
|
11 |
Blower case (2) |
|
12 |
Air intake door |
2. Assemble in the reverse order of disassembly.
Blower Unit
Purpose
The blower unit switches between fresh air and recirculated air (FRESH/REC)
and sends airflow into the cabin.
Function
Air is blown by the blower motor in the blower uni ...
Blower Unit Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Front scuff plate (passenger-side).
b. Front side trim (passenger-side).
c. Dashboard under cover.
d. Glove compa ...
Other materials:
Condenser Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Trunk board.
b. Trunk end trim (LH).
c. Rear scuff plate (LH).
d. Trunk side trim (LH).
e. D-pillar trim (LH).
3. Disconnect the connector.
4. Remove the bolts.
5. Remove the condenser.
6. Install in ...
Front Frame (Rear) Installation [Panel Replacement]
Symbol Mark
Installation Procedure
1. When installing new parts, measure and adjust the body as necessary to conform
with standard dimensions.
2. Drill holes for the plug welding before installing the new parts.
3. After temporarily installing new parts, make sure the related parts fit p ...
Air Bag System Service Cautions [Two Step Deployment Control System]
Air Bag System Component Disassembly
Disassembling the air bag system components could cause it to not operate
(deploy) normally. Never disassemble any air bag system components.
Air Bag Module, Pre-tensioner Seat Belt, Lap Pre-tensioner Seat Belt Handling
Oil, grease, or ...
