Purpose
The blower unit switches between fresh air and recirculated air (FRESH/REC) and sends airflow into the cabin.
Function
Air is blown by the blower motor in the blower unit.
The blower unit switches the air intake port to FRESH or REC based on the position of the air intake door.
Construction
The blower motor consists of the following parts:
Blower motor
Air intake door
Air intake actuator
Air filter
Operation
When the blower motor rotates, air is taken in from the outside of the vehicle or the cabin.
The air taken in flows in the fresh air direction or recirculate direction according to the operation of the air intake link. The air intake port changes by the movement of the air intake door.
Fail-safe
Function not equipped.
Air Bag System Service Cautions [Standard Deployment Control System]
Air Bag System Component Disassembly
Disassembling the air bag system components could cause it to not operate
(deploy) normally. Never disassemble any air bag system components.
Air Bag Module, Pre-tensioner Seat Belt Handling
Oil, grease, or water on the air bag modules ...
Scheduled Maintenance (U.S.A., Canada, and Puerto Rico)
Follow Schedule 1 if the vehicle is operated mainly where none of the following
conditions apply.
• Repeated short-distance driving
• Driving in dusty conditions
• Driving with extended use of brakes
• Driving in areas where salt or other corrosive
materials are used
• Driving on ...
D Pillar Trim Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Trunk board.
b. Trunk end trim.
c. Rear scuff plate.
d. Trunk side trim.
3. Take the shaded area shown in the figure, and remove the D-pillar trim in
the direction of the arrow in the order of (1), (2), (3) wh ...