Purpose
The Blind Spot Monitoring (BSM) warning alarm warns the driver of a possible accident.
Function
If the instrument cluster receives a warning sound request signal from the BSM control module (RH), it sounds the BSM warning alarm using the buzzer in the instrument cluster.
The BSM warning alarm sound pattern is as shown in the figure.
Construction
The BSM warning alarm sounds using the buzzer built into the instrument cluster.
Operation
The instrument cluster receives (1) the warning sound request signal from the BSM control module (RH).
The instrument cluster turns the transistor on (2) based on the warning sound request signal.
When the transistor turns on, a ground circuit with the alarm is established and the alarm sounds (3).
Fail-safe
Function not equipped.
Rear Oil Seal Replacement
1. Remove the transaxle..
2. Remove the flywheel (MTX) or the drive plate (ATX)..
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
1
Rear oil seal
(See Rear Oil Seal Removal Note.)
(See Rear Oil Seal Installation Not ...
Climate Control Unit Removal/Installation [Manual Air Conditioner]
Removal
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Shift lever knob (MTX).
b. Glove compartment.
c. Front console box.
d. Shift panel.
e. Upper panel.
f. Rear console.
g. Side wall.
h. Decoration panel.
i. Front console.
3. Press the tab down, ...
Air Intake Actuator Inspection [Manual Air Conditioner]
1. Connect battery positive voltage to air intake actuator terminal B (or C),
connect terminal C (or B) to ground, and then verify that the air intake actuator
operates as shown in the table.
If the operation condition is not normal, replace the air intake actuator.
...