1. Disconnect the negative battery cable..
2. Remove the BSM OFF switch..
3. Verify that the resistance between BSM OFF switches B and C is as indicated in the table.
If the resistance cannot be verified as indicated in the table, replace the cluster switch.
4. Apply battery positive voltage to BSM OFF switch terminal J, and connect terminal I to ground.
5. Verify that the LED illuminates.
If there is any malfunction, replace the cluster switch.
Floor Covering Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Front scuff plate.
b. Front side trim.
c. Rear scuff plate.
d. B-pillar lower trim.
e. Rear seat cushion.
f. Front seat.
g. Lower anchor of the front seat belt (without lap pre-tensioner seat belt).
h. La ...
High Pressure Fuel Pump Inspection
NOTE:
The following vacuum values are indicated by relative pressure from the fuel
pressure sensor.
1. Verify that the fuel pressure sensor is normal..
2. Connect the M-MDS to the DLC-2.
3. Switch the ignition ON (engine off).
4. Select the “FUEL_PRES”, “LOAD” and “R ...
Front Seat Belt Removal/Installation
WARNING:
Handling the front seat belt (pre-tensioner seat belt) improperly can accidentally
deploy the pre-tensioner seat belt, which may seriously injure you. Read the
air bag system service warnings and cautions before handling the front seat
belt.
(See AIR BAG SYSTEM SERVICE W ...