Mazda CX-5 Service & Repair Manual: Battery Removal/Installation [Skyactiv G 2.0]
1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.
|
1 |
Negative battery cable (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.0].) |
|
2 |
Positive battery cable |
|
3 |
Battery clamp |
|
4 |
Battery, battery box (See Battery, Battery Box Removal Note.) |
|
5 |
Battery box (See Battery Box Installation Note.) |
|
6 |
PCM cover (See PCM REMOVAL/INSTALLATION [SKYACTIV-G 2.0]) |
|
7 |
PCM connector (See PCM REMOVAL/INSTALLATION [SKYACTIV-G 2.0]) |
|
8 |
Battery tray and PCM component (See Battery Tray and PCM Component Removal Note.) |
Battery, Battery Box Removal Note
CAUTION:
-
When removing the battery, do not place the battery on the PCM connector or hit it with the battery. Otherwise, the PCM or PCM connector could be damaged.
1. Remove the battery with the battery box while the battery is positioned at an angle as shown in the figure.
Battery Tray and PCM Component Removal Note
1. Remove the air cleaner, air hose and fresh air duct component..
2. Remove the bolt and nut securing the wiring harness protector to the battery tray.
3. Remove three battery tray bolts so that the battery tray is free to move.
4. Release the wiring harness clips at the three locations shown in the figure and remove the battery tray and PCM component.
5. When replacing the battery tray with a new one, perform the following procedure:
a. Remove the PCM and bracket component.
b. Remove the bracket.
Battery Box Installation Note
1. Install the battery box so that the side with the larger notch faces toward the engine side.
Battery Recharging [Skyactiv G 2.0]
Using GR8-1291:
(See GR8-1291 INSTANT TRAINING MODULE (VIDEO).)
WARNING:
Keep all flames away from the battery, otherwise evaporated gas from the
battery fluid may catch fire and cause se ...
Battery [Skyactiv G 2.0]
Purpose, Function
The battery stores electricity generated by the generator. In addition, it
supplies power to electronic devices if necessary.
Construction
The battery is insta ...
Other materials:
On/Off Solenoid Removal/Installation [Fw6 A EL, Fw6 Ax EL]
WARNING:
A hot transaxle and ATF can cause severe burns. Turn off the engine and wait
until they are cool.
Always wear protective eye wear when using the air compressor. If the air
compressor is used, any particles of dirt or soiling could spatter and get into
the eyes.
...
Hydraulic Variable Valve Timing Actuator
Purpose, Function
The hydraulic variable valve timing actuator operates according to the hydraulic
pressure and changes the phases of the exhaust camshaft. As a result, the open/close
period of the exhaust valve is changed, optimized valve timing in accordance
with driving conditions ...
Cup Holder
WARNING
Never use a cup holder to hold hot liquids while the vehicle is moving:
Using a cup holder to hold hot liquids while the vehicle is moving is dangerous.
If the contents spill, you could be scalded.
Do not put anything other than cups or drink cans in cup holders:
Putting objects other ...
