Mazda CX-5 Service & Repair Manual: Battery
- Battery Inspection [Skyactiv G 2.0]
- Battery Recharging [Skyactiv G 2.0]
- Battery Removal/Installation [Skyactiv G 2.0]
- Battery [Skyactiv G 2.0]
- Negative Battery Cable Disconnection/Connection [Skyactiv G 2.0]
- Remote Transmitter Battery Voltage Inspection
Relay And Fuse Block Removal/Installation
1. Remove the battery tray..
2. Remove the air cleaner case..
3. While pressing the relay and fuse block upper cover tab in the direction of
the arrow (1) shown in the figure, lift up the relay ...
Battery Inspection [Skyactiv G 2.0]
WARNING:
Since battery acid is toxic, be careful when handling the battery.
Since battery acid is highly corrosive, be careful not to allow it to contact
clothing or the vehicle.
...
Other materials:
Sas Control Module Configuration (Using As Built Data) [Standard Deployment
Control System]
NOTE:
If the configuration is performed using As-Built data, the set value of the
personalization function is reset to the initial value (condition when shipped
from factory). Verify the set value with the customer and perform the personalization
function setting after performing th ...
Torque Converter [Fw6 A EL, Fw6 Ax EL]
Purpose/Function
By use of an optimized torus shape (wing) matching the output characteristics
of the engine, the torque converter achieves efficient force transmission and
reduced fuel consumption.
Construction/Operation
A three-member, single-stage two-phase type torque c ...
Mass Air Flow (MAF) Sensor/Intake Air Temperature (Iat) Sensor No.1 Removal/Installation
NOTE:
Because the IAT sensor No.1 is integrated in the MAF sensor, replacing the
IAT sensor No.1 includes replacement of the MAF sensor/IAT sensor No.1.
1. Disconnect the negative battery cable..
2. Disconnect the MAF sensor/IAT sensor No.1 connector.
3. Remove the MAF sensor/IA ...
